Morphy richards 22059 Instructions manual

Ceramic Coated Plates

MODEL22059

DIGITAL CERAMICSTRAIGHTENER

LCD Digital Display

Digital Temperature Control Buttons

On/Off Switch

USING YOUR STRAIGHTENER

After washing your hair, it’s really important to prepare it for styling. If you use lots of heated
styling tools on your hair always use a heat protection spray before you begin styling.
Always dry the excess water from your hair using a towel, and then use a wide tooth comb
to detangle and smooth your hair.

Use your hair dryer until your hair is thoroughly dry. Divide your hair into sections and comb
each section thoroughly. Use the sectioning clips to clip hair out of the way so you can
straighten hair thoroughly.

Use the On/Off button to switch your straightener on. Your straightener is set to switch on
at its minimum temperature of 100°C. You can use the +/– buttons to adjust it to the best
temperature for you. Once the straightener has reached its temperature, the ready symbol
will appear on the display.

Clamp a section of the hair between the straightening plates as close to the roots as
possible. Gently slide the straightener down your hair shaft to the ends. For more difficult
sections of hair, you may need to do this again. Repeat on all sections of the hair.

To find the best heat setting to suit your hair and minimise damage; start with a low setting
120-130ºC for fine hair and 160-170ºC for thick hair and straighten a strand of hair. Keep
increasing the temperature until you can straighten a strand of hair with just two strokes.
This is the optimum temperature for your hair and will help you create perfect styling with
minimum damage.

DON’T FORGET – to switch off your straightener and store when you have finished
straightening. If you want to store your straightener in the gift box, always make sure your
straightener has cooled down and never wrap the cable around the product as this can
cause damage.

Try and clean your straightener regularly for best results. Always do this when the
straightener is switched off and has cooled down.

SAFETY INFORMATION

When using your hair straightener, basic safety precautions should always be followed. Please
read these instructions carefully before using the product and keep them in a safe place for future
reference.

01 This straightener is of a professional standard and reaches very high temperatures. Always

take care not to allow the plates to come into contact with the skin.

02 Do not leave the plates in contact with the hair for more than a few seconds. The straightener

reaches very high temperatures, so there is no need to leave the hair between the plates for
longer than a few seconds. This will avoid unnecessary damage to the hair cuticle.

03 Use the appliance for its intended use only.
04 To protect against the risk of electric shock, do not immerse the appliance in water or any

other liquids.

05 It is recommended that this appliance should not be used by children.
06 Check that the voltage on the rating plate of the straightener corresponds with your house

electricity supply which must be AC (alternating current).

07 Always unplug your appliance when it is not in use.
08 Do not leave the straightener switched on whilst unattended.
09 For UK only - Do not take this product into a bathroom or use near a water basin or

any other vessels containing water. For other European countries - For additional
protection, the installation of a residual current device (RCD) having rated residual
operation current not exceeding 30mA is advised in the electrical circuit supplying
the bathroom. Ask your installer for advice.

2 YEAR GUARANTEE

It is in your interest to retain the retailer’s receipt as proof of purchase. Please
quote the model number if the product develops a fault. This number can be
found on the handle of the product.

All Morphy Richards products are individually tested before leaving the factory. In
the unlikely event of any appliance proving to be faulty within 28 days of purchase it should
be returned to the place of purchase to be replaced.

If a fault develops after 28 days and within 24 months of original purchase, you should
contact the Helpline number quoting the model number of the product, or write to the
address below. You will be asked to return the product (in secure packaging) to the
address below along with a copy of proof of purchase.

The After Sales Division, Morphy Richards Ltd, Talbot Rd, Mexborough, South Yorkshire,
England, S64 8AJ

Helpline (8.30-5.00 Mon-Thurs/8.30-4.00 Fri)

UK 0870 060 2614 • Republic of Ireland 1800409119

For details of the rest of the products in the Morphy Richards range please see our website

www.morphyrichards.com

Morphy Richards products are intended for household use only. Morphy Richards has a
policy of continuous improvement in product quality and design. The company therefore
reserves the right to change the specification of it’s models at any time.

Registered address:

Morphy Richards Ltd, Talbot Rd, Mexborough, South Yorkshire, S64 8AJ

10 After use, do not store until the product has cooled down.
11 Do not place the straightener on surfaces likely to be damaged by the heat.
12 It is normal to find build up of hair products on the straightening plates. For this reason

therefore, you should clean your straightener regularly. Always wait for the plates to cool down
thoroughly before cleaning. Use a damp cloth to remove any build up. If this fails to clean the
plates, try a non abrasive cleaning wipe.

WIRING

This product is fitted with a 13 amp (BS1363) plug. A 13 amp fuse (BS1362) must be used.
Check that the voltage on the rating plate of your appliance corresponds with your house
electricity supply which must be AC (alternating current). If the socket outlets in your home are not
suitable for the plug supplied with this appliance, the plug should be removed and the appropriate
one fitted.

WARNING: The plug removed from the mains lead, if severed, must be destroyed as a
plug with bared flexible cord is hazardous if engaged into a live socket outlet.

MAINS LEAD

As a safety precaution and to prolong the life of your appliance, do not wrap the mains lead
around the appliance as this can cause damage.

Part Number

PC22059M UK rev 1