Morley VAI-2 Owner's Manual

THANK YOU FOR CHOOSING A MORLEY STEVE VAI BAD HORSIE 2 CONTOUR

·

·

·

·

WAH. YOU NOW OWN THE BEST PEDAL MADE!

Please take a few minutes to familiarize yourself with the features of your new pedal. We hope

you enjoy using it as much as we enjoyed building it.

ABOUT OUR ELECTRO-OPTICAL CIRCUITRY:

An LED (Light Emitting Diode) shines on an LDR (Light Dependent Resistor). A shutter alters light
between the two components controlling functions like Wah, volume and switching. Electro-Optical
design ensures smooth pedal control without unwanted noise typical with potentiometer (pot)
controlled pedals.

ABOUT THE CONNECTIONS:
9V: To ensure noise free operation, ONLY Morley's 9VDC 300 milliamp regulated adapter should

be used

IN: Input jack. Plug instrument into this jack using 1/4" guitar cable.
OUT: Connect amplifier to this jack using a 1/4" guitar cable.

USING AN AC ADAPTER:

All Morley pedals use Morley's 9VDC 300 milliamp regulated adapter. Center pin polarity is
negative. Using a non-regulated adapter could cause a low frequency hum in your

amplifier. Using an adapter with the wrong polarity may damage the pedal.

USING A BATTERY:

All Morley pedals are designed to use one 9V battery when not using an adapter. We suggest you
use a good quality alkaline battery. To prolong battery life, unplug your cord completely from the
input jack when not using the pedal. When the pedal is not used for extended periods, remove the
battery from the pedal. Our “Quick Clip” Bettery door allows easy access to battery compartment.

ONE YEAR WARRANTY

All Morley® pedals are warranted for one year with copy of
dated purchase receipt. To obtain warranty service, contact
store where pedal was purchased or email
[e-mail]

BAD HORSIE 2 FEATURES (MODEL VAI-2):

·

SWITCHLESS OPERATION: Simply Step on to engage

Wah and step off to go to bypass.

CONTOUR SWITCH: Selects a second Wah mode
LEVEL: Adjusts the output of the Wah in Contour

Mode

CONTOUR: Adjust the frequncy of the Wah when in

Contour Mode

VAI-2 SPECIFICATIONS:

Power: 9V Battery or 9VDC 300mA regulated (center pin
negative)
Indicator (right): Wah on LED on, Wah off LED off
Indicator (left): Contour Wah on LED on
Dimensions: 9.13" L x 5.88" W x 2.75" H
Current Draw: 12 mA @ 9VDC
Weight: 3.3 lb./ 1.51 kg

www.morleyproducts.com