Morley TMS Owner's Manual

THANK YOU FOR CHOOSING A MORLEY T.M. STEVENS FONK WA H PEDAL.

YOU NOW OWN THE BEST PEDAL MADE!

Please take a few minutes to familiarize yourself with the features of your new pedal. We hope

you enjoy using it as much as we enjoyed building it.

ABOUT OUR ELECTRO-OPTICAL CIRCUITRY:

An LED (Light Emitting Diode) shines on an LDR (Light Dependent Resistor). A shutter alters light between the two components controlling functions like Wah, volume and switching. Electro-Optical design ensures smooth pedal control without unwanted noise typical with potentiometer (pot) controlled pedals.

ABOUT THE CONNECTIONS: 9V: To ensure noise free operation, use ONLY Morley's 9VDC 300 mA regulated adapter. IN: Input jack. Plug instrument into this jack using 1/4" guitar cable. OUT: Connect amplifier to this jack using a 1/4" guitar cable.

USING AN AC ADAPTER:

All Morley pedals use Morley's 9VDC 300 milliamp regulated adapter. Center pin polarity is negative. Using a non-regulated adapter could cause a low frequency hum in your

amplifier. Using an adapter with the wrong polarity may damage the pedal.

USING A BATTERY:

All Morley pedals are designed to use one 9V battery when not using an adapter. We suggest you use a good quality alkaline battery. To prolong battery life, unplug your cord completely from the input jack when not using the pedal. When the pedal is not used for extended periods, remove the battery from the pedal. Remove the battery door located on the bottom of the pedal (a short cord is attached to the door to help prevent loss).

TWO YEAR WARRANTY

All Morley® pedals are warranted for two years from date of purchase. To obtain warranty service, call Morley toll free at 1-800-284-5172 x14.

T.M . STEVENS FONK WA H FEATURES (MODEL TMS):

Switchless Wah Operation: SImply step on to engage

· Wah and step off to go to bypass.

Wah LED: Lights when in Wah mode.

FONK Switch: Selects between traditional Wah (LED

off) and FONK Wa h (LED On).

LEVEL Knob: Adjusts the Wah output level in either

· Wah mode.

Active/Passive Trim Knob: Dial in just the right input

level for passive or active pickups.

TMS SPECIFICATIONS:

Power: 9V Battery or 9VDC 300mA regulated (center pin negative) Indicator: WAH mode LED on, Bypass mode LED off Indicator: FONK Wah LED on, Traditional Wah LED off Dimensions: 9.13" (L) x 5.88" (W) x 2.75" (H) Current Draw: 13 mA @ 9VDC Weight: 3.3 lb./ 1.51 kg

www.morleypedals.com