Morley MTSKW1 Owner's Manual

THANK YOU FOR CHOOSING A MORLEY PEDAL.

YOU NOW OWN THE BEST PEDAL MADE!

Please take a few minutes to familiarize yourself with the features of your new pedal. We hope

you enjoy using it as much as we enjoyed building it.

ABOUT OUR ELECTRO-OPTICAL CIRCUITRY:

Two electronic components contol the On/of and Wah functions of this pedal. A shutter alters light between the two components controlling functions like Wah, volume and switching. Electro-Optical design ensures smooth pedal control without unwanted noise typical with potentiometer (pot) controlled pedals.

ABOUT THE CONNECTIONS: 9V (Right side of Pedal): To ensure noise free operation, ONLY Morley's 9VDC 300 milliamp

regulated adapter should be used

IN (Right side of Pedal): Input jack. Plug instrument into this jack using 1/4" guitar cable. OUT (Left side of Pedal): Connect amplifier to this jack using a 1/4" guitar cable.

USING AN AC ADAPTER:

All Morley pedals use Morley's 9VDC 300 milliamp regulated adapter. Center pin polarity is negative. Using a non-regulated adapter could cause a low frequency hum in your

amplifier. Using an adapter with the wrong polarity may damage the pedal.

USING A BATTERY:

All Morley pedals are designed to use one 9V battery when not using an adapter. We suggest you use a good quality alkaline battery. To prolong battery life, unplug your cord completely from the input jack when not using the pedal. When the pedal is not used for extended periods, remove the battery from the pedal. Our Quick Clip battery door gives easy access to battery compartment.

ONE YEAR WARRANTY

All Morley® pedals are warranted for one year from date of purchase. To obtain warranty service, contact the store where purchased.

DJ ASHBA SKELETON WAH FEATURES (MODEL MTSKW1):

SWITCHLESS: Simply step on to engage Wah, step off to

go to bypass.

ELECTRO-OPTICAL: No pots to get scratchy or go bad! INTERNAL WAH LEVEL: Internal trimpot lets you

customize the output level of the Wah

MTSKW1 SPECIFICATIONS:

Power: 9V Battery or 9VDC 300mA regulated (center pin negative) Indicator: Wah Engaged, Bypass LED off Dimensions: 6.85” L x 4.5” W x 2.5” H Current Draw: 10 mA @ 9VDC Weight: 2.1 lb./ 1.0kg

www.morleyproducts.com