Morley ELC Instruction Manual

Thanks for buying the Morley Effects Loop Corrector

POWER REQUIREMENTS: The Effects Loop Corrector is a passive device (does not need a battery or power adapter).

CONNECTION NOTES: Ty p ically, standard mono guitar cables (TS - Tip/Sleeve) are used with this device. When using stereo

effects in an Effects Loop that accepts stereo cables (TRS - Tip/Ring/Sleeve), the Effects Loop Corrector will also accept stereo
connectors.

WHAT IS AN EFFECTS LOOP (FX LOOP)? An Effects Loop consists of SEND and RETURN jacks typically found on the back
panel of many guitar amplifiers. An Effects Loop is are used to hook up effect(s) so the player can plug directly into the amp
input for the strongest guitar signal and uninterrupted tone from both the guitar and the effect(s).

WHY MIGHT I NEED TO CORRECT MY FX LOOPS SIGNAL? The actual level of effects loops signal varies from amp to amp.
Correcting the FX Loop signal will provide a proper signal for the effects and result in better overall tonality.

WHEN EFFECT LOOP LEVEL IS TOO HOT: Some Effects Loop signals are too hot and will cause effects to distort - follow
Set Up Diagrams #1 or #2 to solve this.

WHEN EFFECTS LOOP SIGNAL IS TOO WEAK: Some Effects Loop signals are too weak and lack the presence and
headroom for a full pleasing tone - Follow Set Up Diagrams #3 or #4 to solve this.

Set Up Diagram #1 Set Up Diagram #2

Decreasing FX Loop signal, then

increasing signal to FX Loop Return

Set Up Diagram #3 Set Up Diagram #4

Increasing FX Loop signal, then

decreasing signal to FX Loop Return

Decreasing FX Loop signal with
straight feed to FX Loop Return

Increasing FX Loop signal with

straight feed to FX Loop Return

This product is proudly made in the U.S.A.

Sound Enhancement Products, Inc. 325 Cary Point Drive Cary IL 60013

www.morleypedals.com