www.moosesound.com 5
Connections and Controls
Procedures
MAN181_0
1. - Connect correctly and according to your installation all the Lamps to their respective outputs: D1216 ( 10 / 11 /
12 ), D1216S ( 13 ) and D1216H ( 14 / 15 );
2. - Following the scheme of the Rear Panel, connect the 3 phases, Neutral and Ground ( 9 ); For D1216S, connect
the Mains Supply Cable;
3. - Verify that all Circuit Breakers ( 1 ) are in "ON" position;
4. - Using a screw-driver, turn Preheat Selector ( 2 ) Clockwise until Lamps filament bright up;
5. - Choose the Input Connection: DIGITAL ( DMX ) or ANALOG ( 0 - 10V );
A - DMX Connection:
a) Connect the cable from Mixer to DMX CONTROL INPUT ( 6 );
b) Using DMX SELECTOR ( 4 ), choose the channel that you want your dimmer to start with.
As an example to work with channels 1 -12, DMX Selector ( 4 ) must be like the picture:
0 0 0
9
9
9
8
8
8
7
7
7
6
6
6
555
4
4
4
3
3
3
2
2
2
1
1
1
1. CIRCUIT BREAKERS: Individual short-circuit protection (magnetotermics) for each channel - 1 to 12.
2. PREHEAT: When properly used, this feature enable to extend Lamp life time - very important.
3. PHASE INDICATOR: LED indicator of active phase inputs.
4. DMX SELECTOR: Allows the user to select in what channel the dimmer is going to start with.
5. ANALOG OUT: Analog control Input ( 0 -10V ) to connect the cable from Mixer ( 0-10V ) in D15.
6. DMX IN: DMX control Input to connect the cable from Mixer ( DMX ) in 3-pin XLR.
7. DMX OUT: DMX output seful to connect ( Link ) another Dimmer in 3-pin XLR;
8. ACTIVE DIMMER OUTPUT: LED indicator of active outputs;
9. MAINS SUPPLY: Phase 1 - 3, Common and Ground Clamps. For D1216S it´s a mains supply cable;
10. OUTPUT TERMINALS: Channels 1 - 4 with Neutral / Ground Clamps;
11. OUTPUT TERMINALS: Channels 5 - 8 with Neutral / Ground Clamps;
12. OUTPUT TERMINALS: Channels 9 - 12 with Neutral / Ground Clamps;
13. SHUKO OUTPUTS: Shuko socket for each channel 1 to 12;
14. HARTING OUTPUT A: Harting socket for output channels 1 to 6: pin numbers are shown on the rear panel;
15. HARTING OUTPUT B: Harting socket for output channels 7 to 12: pin numbers are shown on the rear panel;
D1216
12x 3000W DMX Dimmer