Scan for more
USER MANUAL
ROCKME SPEAKER LAMP
Safety Warnings - Precautions
• Keep this product out of reach of children younger than 8 years of age.
• Do not permit children to play with this appliance.
• This device should not be used by persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge unless they have been given supervision or instruction
concerning use of this appliance in a safe way and understand the hazards involved.
• Cleaning and maintenance should not be done by children without supervision.
• Never place the unit or accessories near heat sources, open ames or on hot surfaces.
• Only use the original accessories and power supply.
• The power supply may generate heat while charging. Make sure that they are well ventilated.
• If the unit or one of its accessories is damaged, do not attempt to repair.
• Do not disassemble the unit or its accessories.
• Repair may only be carried out by an experienced technician.
• Use a damp cloth to clean the unit and its accessories. Do not use aggressive chemicals, cleaning
solvents or strong detergents.
Caution: This Lantern contains a rechargeable Li-ion battery. The remote control contains a button
cell battery. At the end of their lifetime, these batteries should be recycled.
Please read more about environmental recommendations under “Environmental recommendations” in
this manual.
Never short-circuit, open or expose a battery to heat or throw into re as it can explode and cause
serious personal injury.
Introduction
Thank you for purchasing this Mooni Product.
This manual contains important operating and safety instructions and we advise you to read and
save this manual.
Contents
1x Mooni RockMe Speaker
Lamp
1x USB to Micro-USB 2m
cable
Charging
1. Before rst use, a full charge of the internal
battery will be necessary.
2. Insert the USB cable into the Micro-USB port
on bottom or side of the lamp.
3. Connect the USB Cable into any 5V USB power
socket. For example, a computer/laptop, vehicle,
power bank, or USB power adapter.
4. A red light will indicate when the product is
being charged. The red light will turn off when
the product is fully charged.
5. Disconnect the USB cable from the lamp and
1x Remote control
the power source. The Mooni product is now
ready to use.
How to take care of the internal battery:
Partial discharges with frequent recharges are much healthier for the li-ion battery than a long deep
discharge.
A full charge of the product immediately after purchase and before use is recommended.
During a long storage period of your product, try to keep the li-ion battery at a charged level of about
50%.
Note: The integrated rechargeable battery will lose its energy even while the product is not being
used. The rate of self-discharge is dependent on the state of charge, ambient temperature and other
factors.
Basic Instructions - Master Button
1. Use the On/Off button located on the bottom plate of the
product.
2. Press the button to switch the product on.
3. Press repeatedly to choose the desired color or color mode.
4. Press and hold the button for more than 1 second to switch
the product off.
The product can produce light in multiple colors and in 4 different lighting modes. You can select
these different colors and modes by pressing the button described above or by using the remote
described below.
Basic Instructions - Remote
1. Press the button to switch the lamp and speaker On/Off
to only turn the speaker On/Off.
bottons to adjust the light intensity.
button to select or change color.
6m
distance
or press the
2. Use the TOP +/-
3. Use the
4. Use the MODE button to choose the desired color mode.
5. Amplify the volume by pressing the BOTTOM +/- buttons.
6. Press the or buttons to skip or rewind tracks.
Bluetooth & Speaker
We offer Bluetooth technology to stream music to your Mooni Product with any Bluetooth device.
This Mooni Speaker is equipped with Bluetooth chip 4.2. This means you can connect up to 2 Mooni
Speakers with your smartphone/tablet.
1. Press the
speaker by pressing the button on the bottom of the Mooni product to turn on the speaker. You will
hear a tone after you turn on the speaker.
2. Move near the Mooni Product.
3. Activate the Bluetooth function on your Bluetooth device. It may take a while before “Mooni” is
shown in the Bluetooth devices list.
4. Select “Mooni” to make the connection.
5. Once connected to “Mooni”, press play on the music application of your choice and enjoy.
or button on the Mooni Remote to turn on speaker function. You can also turn on the
Stereo pairing
This Mooni speaker is Stereo Ready. If you have two Stereo Ready speakers close to each other,
they will automatically sync together and bring you true stereo sound. You only have to connect your
bluetooth device with one of the Stereo Ready Mooni speakers. The other speaker will automatically
connect.
lf you purchased both speakers together and are pairing them both for the rst time:
1. Turn ON both stereo ready speakers. You will hear the rst tone indicating it is ON.
2. Wait for the secondary tone from both speakers indicating that they have connected to each other
(this can take several seconds).
3. Now, follow steps 2 to 5 in the Bluetooth Connection Instructions to connect (Your bluetooth
device will select one speaker to connect to).
lf you are adding a new stereo ready speaker to one you purchased previously:
1. With both speakers OFF, go to your Bluetooth setting on your device and ”forget” or ”remove” the
previously saved Mooni device(s).
2. Turn OFF your Bluetooth on your device.
3. Turn ON both stereo ready speakers. You will hear the rst tone indicating it is ON.
4. Wait for the secondary tone from both speakers indicating that they have connected to each other
(this can take several seconds).
5. Now, follow steps 2 to 5 in the Bluetooth Connection Instructions to connect (Your bluetooth
device will select one speaker to connect to).
Technical Specifications
Dimensions: 260 x 222 mm
Usage time: 4-12h
Charging time USB: 4-8h
Built in rechargeable battery: 3.7V Li-ion 2000mAh
Lifetime LED: 20 000h
Storage temperature: -25°C ~ 60°C
Storage humidity: 20 ~ 90%
Button cell remote control: CR2032 (non-rechargeable) 3V lithium
Rated Voltage: 100-240VAC for adapter;
3.7Vdc Lithium battery for luminaire
DC 5V 1A USB
Rated Frequency: 50/60Hz for adapter
Rated Power: LED: 5W; Speaker: 10 W
Protection Class: Class II for adapter;
Class III for luminaire
Degree of Protection: IP 44 for luminaire;
IP 20 for adapter and DC 5V 1A USB
Classication of radiation RG0
FOR ADAPTER
WARNING:
The light source contained in this luminaire shall only be replaced by the manufacturer or his service
agent or a similar qualied person. If the external exible cable or cord of this luminaire is damaged, it
shall be exclusively replaced by the manufacturer or his service agent or a similar qualied person in
order to avoid a hazard. If the external exible cable or cord of this luminaire cannot be replaced; or if
the cord is damaged, the luminaire should be destroyed.
FOR LUMINAIRE
Environmental Recommendations
Regarding used batteries
The customer should return used batteries to a collection box for battery recycling.
Regarding waste from electrical and electronic equipment (WEEE)
This symbol on the product or the packaging indicates that the equipment
carrying this mark must not be thrown into general waste but should be
collected separately and properly processed under local regulations. The
appropriate take-back systems will reuse or recycle most of the materials of
your end-of-life product in an ecological way to diminish the pressure on natural resources. Please contact your local waste administration if you need more
information on the collection system.
Warranty and Warranty Limitations
This Mooni product is warranted to be free from defects in material and operation for one year. In the
unlikely event that it is found to be defective within this period of time, the importer/manufacturer will
repair or replace it. When returning the defective product, the sales receipt must be enclosed.
The Warranty does not cover: problems caused by abuse or by environmental conditions that are
not in conformance with the recommended operations of the product. Accidental or deliberate
damage, repairs or product alterations made by persons without written consent from Mooni
are also not covered. Batteries are considered wear parts therefore they are not included in the
warranty. The product does not function properly due to problems with connection and/or access
to your Bluetooth™ device (e.g. Such as a cell phone, tablet, computer). Abnormal voltage. Under
no condition can the importer/manufacturer be held liable for damage to items or appliances for
incidental or consequential losses or expenses incurred. This does not affect your statutory rights.
Warranty:
1 Year - Materials & Operation (as detailed above)
For questions:
Motiv Brands
sales@motivbrands.com.au
Phone: 1300 032 005
www.motivbrands.com.au/mooni
Subject to typographical errors
Scan for more
Loading...