Moog VCP-251, VX-351, VX-352 User Manual

VX-351/VX-352/CP-251 RACK MOUNT KIT

ASSEMBLY INSTRUCTIONS

This rack mount kit can be used with both the VX-351(2)

Voyager™ CV Expander and the Moogerfooger® CP-251

Control Processor. It takes up 3 rack spaces in a standard 19”

equipment rack.

Possible assembly configurations include:

| 1 or 2 VX-351(2)s

| 1 VX-351(2) + 1 CP-251

| 1 or 2 CP-251s

THESE INSTRUCTIONS WILL COVER THE
INSTALLATION OF 1 VX-351/VX-352 + 1 CP-251.

To complete the assembly, you will need the following tools:

| #1 Phillips screwdriver (medium small)

| A small pair of utility pliers or a 1/4” spinite wrench

You should also have a clean workspace where you can perform the
assembly without scratching the chassis of the VX-351 or the CP-251

GET STARTED

Identify the hardware components that come

with this rack mount kit. You should have the

following items:

a) b)

a) 2 - ½” nylon hole plugs

b) 4 - #10 finishing washers

c) 4 - 10-32 x ½” oval head machine screws

d) 8 - 4-40 x ¼” oval head machine screws

e) 8 - 4-40 kep nuts

f) 1 - Center Block

g) 1 - daisy chain power harness

h) 1 - rack mount frame

STEP 1:

Remove the back panel from the VX-351(2). Set

aside the rubber feet with their mounting screws.

c)

d)

e) f)

g) h)

[STEP 2]

STEP 2:

Carefully remove the back panel from the CP-251.

The power connector on the CP-251’s back panel is

plugged into the Circuit board inside. Unplug the

+9V power connector from the CP-251 circuit

board. Set the rubber feet and their mounting

screws aside.

STEP 3:

Carefully remove all four wood end caps and save

the wood screws. Be careful as you remove the

screw not to strip the heads of the screws.

[STEP 3]