Installation and Operating Instructions
Built-In 4 Zone Ceramic Hob
MODEL: CS440
(Please note that this picture is shown for indicative purposes only)
Please read these instructions carefully before attempting to install or use this appliance.
It is advisable to keep these instructions in a safe place for future reference.
2
Introduc
t
ion
and
ion
le
T
his applian
ce must be installed
and
conne
cted in
montpellier
Thank you for choosing this
branded
appliance. It has been designed to give years of troublefree use provided it is installed and maintained correctly.
Please read these instructions carefully before installing or
using your appliance. It is advisable to keep your purchase
installation receipts with these instructions in a safe place for
future reference. Included is some important safety informat
in addition to guidelines and recommendations that will enab
you to take full advantage of all the functions available.
This quality appliance has been tested and certified to meet all
applicable UK electrical and safety standards.
accordance with current regulations.
After unpacking the appliance ensure that there is no visible
damage. If the appliance has been damaged during transit,
do not use it, contact your retailer immediately.
Your 2 year Manufacturer's guarantee
THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS.
Your new montpellier appliance carries a free guarantee which protects you against the
cost of repairs during the first 24 months from date of purchase provided that:
Any claim is accompanied by evidence of the model reference, model serial number and
proof of purchase, such as a Sales Receipt, showing that the appliance was purchased
within the 24 months prior to the date of claim.
What is not covered under the Guarantee:
· Any appliance not correctly installed and operated in accordance with the
manufacturer's instructions.
· Any appliance that is used for anything other than domestic purposes.
· Any defect caused by accident, misuse, unauthorized modification or inexpert repair.
· Cost of Call-out where a fault cannot be found with the appliance.
· Cost of Call-out for work covering routine maintenance, such as, but not exclusively,
cleaning of filters or defrosting.
· Cost of Call-out for work required to correct the alignment of doors following door
reversal procedures carried out by you.
· Use of the appliance by anyone other than the Householder.
· Use in any commercial environment.
· Consumable items, such as, but not exclusively, fuses in plugs, bulbs and breakable
items which require routine replacement.
· Repair costs incurred that have not been authorised by Repairtech and/or carried out
by a non-approved Repairtech engineer.
YOUR GUARANTEE IS VALID ONLY IN THE UK.
To Register your Appliance simply complete the card in your appliance pack and return it
with a stamp affixed or Alternatively you can Register online at www.repairtechuk.com
Should your appliance develop a fault, please call the
Repairtech Service Helpline on: 01527-888133
Please remember to have all your product details available, including the model number,
serial number, date of purchase and your retailer’s details before registering a fault.
Your service call cannot progress without this information.
3
SERVICE HELP-LINE
Description of the Appliance
(Image shown for indicative purposes only)
4
CONTENTS:
Section 1. Safety Advice
Section 2. Installation
Section 3. Operating the Appliance
Section 4. Maintenance
5
Section 1. Safety Advice
- This appliance must be connected by a qualified electrician.
- Please read this booklet thoroughly before installing and switching on the
appliance. The manufacturer accepts no responsibility for incorrect
installation and usage.
- This appliance is guaranteed for Domestic Use Only.
- The appliance is not intended for use by persons (including children from
age 8) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that they do not
play with the appliance.
- This appliance must only be used for cooking/heating foods and liquids.
Do not use it for any other purpose.
- Do not twist or bend the cables, and keep them away from hot surfaces.
- Following installation make sure that the power cable is not trapped
underneath the appliance.
-
Keep the appliance surfaces clean. Failure to do this could lead to the
appliance malfunctioning.
-
The surface of this appliance will get hot during use. Take care when
using the appliance and keep children well away.
-
The surface of this appliance will remain hot after it has been turned off.
Do not touch or clean the heating zone until it has completely cooled
down.
- If the power supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
- WARNING: The appliance and its accessible parts become hot during
use. Care should be taken to avoid touching heating elements. Children
less than 8 years of age shall be kept away unless continuously
supervised.
- WARNING: Unattended cooking on a hob with fat or oil can be
dangerous and may result in fire. NEVER try to extinguish a fire with
water, but switch off the appliance and then cover flame e.g. with a lid or
a fire blanket.
- WARNING: Danger of fire: do not store items on the cooking surfaces.
- WARNING: If the surface is cracked, switch off the appliance to avoid the
possibility of electric shock.
- The appliance is not intended to be operated by means of an external
timer or separate remote-control system.
- Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
oven door glass and other surface since they can scratch the surface,
which may result in shattering of the glass or damage to the surface.
- Do not use steam cleaners when cleaning the appliance.
6
Section
2
. Installation
- Remove all packaging, protective film and securing tape from the appliance.
- Position the appliance in a dry atmosphere.
- The following dimensions are provided as a guide for installation – your installer will
carry out the installation in accordance with the current regulations.
- This appliance must be connected by a suitably qualified electrician who will connect
the power cable in accordance with the current regulations.
To install this appliance, please proceed as follows:
2.1 Work-Surface Cut-Out
2.2 Securing the Hob
Apply the self-adhesive sealing tape all the way around the lower edge of the cooking
surface as seen in the below diagram. Screw the 4 worktop mounting brackets on the
side walls of the product.
Now position the hob into the work surface cut-out to secure it into place.
7
2.3 Electrical Connection
This appliance must be ‘hard wired’ to a suitable fused point adjacent to the
appliance housing and protected with a 32 amp fuse. Please note that a switchable
spur should be accessible above the work surface to allow the power to be turned off.
Note: This hob cannot be connected via a 3pin plug!
Your installer will connect this appliance in accordance with current regulations.
Electrical connection diagram:
8
Section 3. Operating the Appliance
3.1. Control Panel
3.2. Power and Cooking Functions
3.2.1. On-Off
To turn the required heat zone on or off, turn the control knob to the required heat
setting. The red power indicator will be illuminated whilst the hob is on.
To turn the heat zone off, turn the control knob to zero.
3.2.2. Setting the Heat Zone Temperature
Turn the control knob between the low to high settings, 1 being low and 6 being high.
When you have finished with the heat zone, turn the control knob to zero (0). Please
note that some models contain dual and oval heaters which have 2 heating zones. If
applicable, you can activate the additional zone by turning the knob to position.
3.2.3 Residual Heat Function
The residual heat indicator lamp will come on after the cooking process if there is heat
still present in the vitro-ceramic glass giving it a temperature of 60C or more.
9
Rear Right Heat Zone
Rear Left Heat Zone
Front Left Heat Zone
Front Right Heat Zone
10
If after the previous checks there is still a fault, please
Section 4. Maintenance
Before any maintenance or cleaning work is carried out, DISCONNECT the
appliance from the ELECTRICITY supply and ensure that the appliance is
completely cool.
4.1. Cleaning the Hob Surface
Clean spillages from the hob surface as soon as possible after use. Always ensure
that the surface has cooled down before cleaning.
Use a soft cloth or kitchen paper to clean the surface.
Do not use other abrasive cleaners and/or wire wool etc as this may scratch the
surface of the hob.
4.2. What to do if something goes wrong
There is no power to the appliance:
- Check there is not a power cut
- Check there is power to the electrical connection
After cooking the letter ‘H’ is displayed:
- This is the hot surface indicator – it will remain on until the appropriate heat zone has
cooled to a temperature of 60C or less.
After switching off, the appliance sounds like it is still running:
- This is the cooling fan – it will remain on until the appliance has cooled down to a
level which is not potentially harmful.
contact the Repairtech Service Helpline below. Please
ensure that you have the model number, serial number,
date of purchase and retailers information available before
you make the call.
Should your appliance develop a fault, please call the
Repairtech Service Helpline on:
01527-888133
11
Important Note:
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product.
The symbol on the product, or on the documents accompanying the
product, the Crossed Out Wheelie Bin, indicates that this appliance
may not be treated as household waste. Instead it shall be handed
over to the applicable collection point for the recycling of electrical
and electronic equipment.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal. For more detailed
information about treatment, recovery and recycling of this product,
please contact your local authority, your household waste disposal
service or the retailer where you purchased the product.
We continuously try to improve our products for the benefit of our customers.
For this reason we reserve the right to make changes to any
product at any time, without notice.
Issue: 02/02-03-2015
Loading...