Montigo HFK50 User Manual
Installing the HFK50 Fan Kit for Proame 2
US
Fan Kit
For use with:
H*34-DF/DL; L38-DF
H*38-DF/DL; L42-DF
H*-DF/DL; L52-DF
* = C, L, P, R, W
®
C
General Information
This blower kit is for installation with the models listed above.
CAUTION
Ensure that all power to the appliance is off at the electrical breaker or fuse
before beginning installation. Ensure gas is turned off at the shutoff valve before
beginning installation.
This kit should be installed by a qualied person.
Check local codes and read all instructions prior to installation.
Installation
1. Remove burner tray if required (follow instructions in the replace
installation manual).
KIT # Contents
HFK50 2x blowers, 1x fan cord assembly with heat sensor
switch, Fan Speed Controller with Dual Receptacle
(DRB001), 4x mounting screws, Velcro strips,
self-adhesive cable tie mounts and cable ties.
Before You Begin
Ensure that the power supply has been turned off at the breaker or
fuse before beginning the installation.
Shut off the gas supply at the shut-off valve, and ensure that the main
burner and pilot light have been turned off and the replace has been
cooled off for at least two hours be fore installation.
Cable ties &
mounts
Left fan Right fan
Fan mounting screws
Fan Harness Power Cord
with heat sensor
Dual Receptacle control box
(DRB001)
17
Burner Tray Gasket
Figure 2 Removing the burner tray (L38DF, L42DF, L52DF
models only).
18
Burner Tray Gasket
Figure 1 Contents of HFK50 Fan Kit package.
Page 1
Figure 3 Removing the burner tray (L38DF, L42DF, L52DF
models only).
XT0014 - 092214
Installation
2. Install the left fan as shown in Figure 4 to the bracket underneath
the rebox using the screws supplied (motor should be oriented
towards the back side of the replace).
Figure 4 Install left fan to bracket
3. Install the right fan as shown in Figure 6 to the bracket underneath
the rebox using the screws supplied (motor should be oriented
towards the back side of the replace).
4. Attach the DRB001 using the supplied Velcro strips to the oor of
the replace. Note: ensure that control box clears the door buckle.
Figure 6 Attach the DRB001
5. Plug DRB001 Power Cord to the PPO box.
PPO
Door
Box
buckle
Page 2
Figure 7 Plug in power cord to PPO
Figure 5 Install right fan to bracket
XT0014 - 092214
Loading...