Monte Carlo Fan Company MCRC1, MCRC1R, MCRC2R, MCRC3, MCRC3R Installation And Operation Instruction Manual
...
CEILING FAN REMOTE CONTROLLER
INSTALLATION AND OPERATION INSTRUCTION
CONTENTS
Safety information ......................................................................................................................... 1
General guide................................................................................................................................2
Function chart................................................................................................................................ 3
Remote control setting (Dimming/Non Dimming) .......................................................................... 3
Installation and wiring....................................................................................................................4
Remote control setting and operation ........................................................................................... 7
Trouble shooting and warranty...................................................................................................... 9
SAFETY INFORMATION
READ AND SAVE THESE INSTRUCTIONS
• Please read and understand this entire manual before attempting to assemble, install or operate
the product.
• Make sure that all electrical connections comply with local codes, ordinances, the National
Electrical Code and ANSI/NFPA 70-1999. Hire a qualified electrician or consult a do-it-yourself
wiring handbook if you are unfamiliar with installing electrical wiring.
• Before proceeding, be sure to shut off electricity at main switch or circuit breaker in order to avoid
electrical shock.
MCRC1, MCRC1R, MCRC2R, MCRC3,
MCRC3R, MCRC4R series
General Guide
This remote controller operates with 3V CR2032 battery (battery included).
Store the remote controller away from excess heat or humidity
Make sure the fan is set on HIGH speed and the light is in the ON position by pull chain
controls originally supplied with your fan.
For downrod mount fans- Remove Ceiling fan CANOPY from its mounting bracket and
disconnect existing wiring for Remote control receiver installation and wiring. Replace it
after installation.
For Flush mount fans- Remove Ceiling fan housing or mounting bracket from mounting
plate and disconnect existing wiring for Remote controller receiver installation and wiring.
Replace it after installation.
Warning: Before proceeding, be sure to shut off electricity at main switch or circuit breaker in
order to avoid electrical shock.
Note
: Fan installation must be complete including assembly of blades before testing remote
control unit.
Note: Refer to your Ceiling fan instruction manual for Safety and installation instruction.
This remote controller is to be used for the control of ceiling fan only, and in an AC 120V
60HZ power supply only.
The power supply to the remote control receiver should be connected through a switch, i.e.
existing wall switch.
Do not use the remote controller with SOLID-STATE fans.
Do not use the remote controller with outdoor fans.
© 2013 Monte Carlo Fan Company
Customer Service
800-969-3347
Customer Service Center
7400 Linder Ave.
Skokie, IL 60077
www.montecarlofans.com
2
9/25/2013
I
tem number VS Function
Model\Function Fan Speed Fan off Reverse Light Up light SKU #
MCRC1 series v v v MCRC1, MCRC1AL
MCRC1R series v v v v MCRC1RR
ZW/RB/BS/PN/BP, MCRC1RALRZW/RB/BS/PN/BP
MCRC2R series v v v v v MCRC2RRZW/RB/BS/PN/BP, MCRC2RALRZW/RB/BS/PN/BP
MCRC3 v v v MCRC3
MCRC3R series v v v v MCRC3RR
ZW/RB/BS/PN/BP
MCRC4R series v v v v v MCRC4RRZW/RB/BS/PN/BP
MCRC1T series v v v MCRC1T, MCRC1TAL
MCRC1RT series v v v v MCRC1RT, MCRC1RTAL
MCRC2RT series v v v v v MCRC2RT, MCRT2RTAL
MCRC3W v v v MCRC3W
MCRC3RW v v v v MCRC3RW
MCRC4RW v v v v v MCRC4RW
MCRC-RC1 v v v MCRC-RC1
MCRC-RC1R v v v v MCRC-RC1R
MCRC-RC2R v v v v v MCRC-RC2R
REMOTE CONTROL SETTING (Dimming/Non Dimming)
Dimming Non Dimming Setting
The “DIM” selection is the light dimmable selection and it
is to be used with incandescent light bulbs including
halogen bulbs and dimmable LED luminaries. The
“ON/OFF” selection is the light ON/OFF only (non
dimming function) and it is to be used with CFL bulbs
and other non dimmable luminaries. (Fig. 1 )
Warning: The remote controller is set with dimming
function at factory, make sure to select “ON/OFF”
(non dimming function) when use this remote
controller with CFL and other non dimmable
luminaries. Wrong setting may damage the light kit
or the remote controller.
Caution: If the remote receiver has been wired with fan,
turn power off by wall switch before switch “DIM” and
“ON/OFF” selection.
Canopy type receiver
ON/OFF
DIM
Switch housing type
receiver
© 2013 Monte Carlo Fan Company
Fig. 1
3
9/25/2013
Loading...