Monte Carlo Fan Company CKF310 Instructions Manual

CKF310-ENG

CKF310

For Monte Carlo Remote

CAUTION: To reduce the risk of electric shock,

install only in Fan

1. Model CD-52, manufactured by Ja Yang (E106510)

2. Model 9701, manufactured by Furn Fan (E141261)

3. Model AC-552, manufactured by Air Cool (E75795)

CAUTION : FOR CONTROL OF SHADE POLE, PERMANENT SPLIT

CAPACITOR, OR UNIVERSAL MOTORS ONLY.

1

Caution: Turn off power at fuse box to avoid

possible electrical shock.

4

2

Top view of switch housing plate.

5

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

3

Disconnect Molex Connectors in switch housing
plate by pushing down on tab and pulling the
two (molex connectors) apart.

6

Connect the molex from the receiver to the
molex in the switch housing plate by aligning
and sliding together. Note: For longer distance
operation, coil receiver antenna around the
natural wire (white wire).

Set dip switches on the Remote Transmitter and
Remote Receiver to the same settings. This
must be done so the units will communcate
properly. If you have other fans you can set to
control from one transmitter by setting both
receivers the same as the transmitter. If you
have more than one fan with remote. You can
set the dip switches to different positiosns to
have seperate control.

Align gap in receiver with the screw between
speed switch and reverse switch and slide
receiver (Dip switch facing housing plate) into
switch housing plate. Receiver should fit direct­ly into area in the switch housing plate. Note:
If installing light kit, use the blue and white
wire from the receiver.

The wall control transmits the command signals via radio waves to the receiver
installed in the fan’s hanging bracket or on the fan. The receiver is required for

the wall control to function. Power for the wall control comes from the 12V bat-

tery located in the wall remote. Duracell MN21 / Eveready A23 / GP 23A all 12V.

The frequency switches (dip switches) on the wall control and the receiver have

been preset at the factory. Please recheck to make sure the switches on the wall

control and receiver are set to the same position. Any combination of settings are

fine as long as the wall control and ceiling fan receiver are set to the same posi-

tion.

CAUTION: TURN OFF POWER AT FUSE BOX TO AVOID POSSIBLE ELECTRICAL SHOCK.

1

Remove cover by snaping off from top or bot­tom. Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 / Eveready A23
/ GP 23A all 12V.

3

WALL MOUNT INSTALL

2

Place face plate over battery compartment and
buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over 4
pins and snaping into place.

HAND HELD INSTALL

4

Install wall control unit to outlet box
using machine screws provided.

Attach front cover to wall control
with screws provided. Snap battery
cover in place.