Montague SL115AP Operator’s Manual

INSTRUCTION MANUAL

addendum

MONTAGUE SL

Gas Convection Ovens

with

Solid State Electronic Controls

MODELS:

SL70 (AH, AP) and SL2-70 (AH, AP)

This manual is meant as a supplement to the Gas Vectaire manual. The

contents herein describe the function and operation of the Solid Electronic

Controls. For information on the Gas Vectaire oven installation, operation,

maintenance, service and parts, refer to the Gas Vectaire manual part no.

4520-9.

These instructions should be read thoroughly before attempting installation.

Set up and installation should be performed by qualified installation personnel.

Keep area around appliances free and clear from combustibles.

PLEASE RETAIN THIS MANUAL

FOR FUTURE REFERENCE.

THE MONTAGUE COMPANY

1830 Stearman Avenue P.O. BOX 4954

HAYWARD,CA 94540-4954

TEL: [phone] FAX: [phone]

CONTENTS

INTRODUCTION, INSTALLATION & CAUTIONS 2
OPERATION (Cooking with Solid State Controls) 3-7
WIRE DIAGRAMS 8

IMPORTANT

WARNING:
Improper installation, adjustment,
alteration, service or maintenance
can cause property damage, injury
or death. Read the operating
and maintenance instructions
thoroughly before installing or

Do not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or
any other appliance.

FOR YOUR SAFETY:

servicing this equipment.

INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE USER SMELLS GAS MUST BE
POSTED IN A PROMINENT LOCATION. THIS INFORMATION MAY BE OBTAINED BY
CONSULTING THE LOCAL GAS SUPPLIER.

SHIPPING DAMAGE CLAIM PROCEDURE

For your protection, please note that equipment in this shipment was carefully inspected
and packed by skilled personnel before leaving the factory. The transportation company
assumes full responsibility for safe delivery upon acceptance of this shipment.

If shipment arrives damaged:

1. VISIBLE LOSS OR DAMAGE—Be certain this is noted on freight bill or express receipt,
and signed by person making delivery.

2. FILE CLAIM FOR DAMAGES IMMEDIATELY—Regardless of the extent of damage.

3. CONCEALED LOSS OR DAMAGE—If damage is unnoticed until merchandise is un-
packed, notify transportation company or carrier immediately, and file “concealed dam­age” claim with them. This should be done within fifteen (15) days of date that delivery
was made to you. Be sure to retain container for inspection.

We cannot assume responsibility for damage incurred in transit. We will, however, be glad
to furnish you with necessary documents to support your claim.

2

3 4

INTRODUCTION

The SL series Vectaire gas convection ovens are very similar to the Vectaire ovens Montague
has produced for years. The most significant difference is that solid-state electronic controls are
used instead of the elecro-mechanical ones commonly used. The result is the most accurate,
responsive and predictable ovens we have ever offered with the recognized dependability of
solid-state components.

This special manual is meant to be used as a supplement to the main "Vectaire Gas Convection
Ovens" instruction manual, which should be reference first for special instructions.

INSTALLATION

Montague's general installation instructions should be followed. In addition, since solid state
components have a very short life span when exposed to temperatures above 185°F,
(85°C), certain installation precautions are necessary. The SL ovens have been designed to
operate well below this temperature when installed properly, and the following cautions are
observed:

Caution

1. Do not obstruct the air out the vent holes at the top of the oven, or the flow of fresh
room air to the oven bottom or lower front portion of the burner access cover.

2. Do not mount the oven on a solid curb unless it has been modified at the factory for
this type of operation.

3. When stacking ovens, never reverse the top and the bottom ovens.

4. Never stack an SL convection type oven with a standard Vectaire, or any other type
of oven without first consulting the factory. Certain ovens are not compatible, or a

stacking kit may be required.

Special Caution

DO NOT PLACE HIGH HEAT PRODUCING EQUIPMENT ADJACENT TO THE RIGHT SIDE
OF AN "SL" VECTAIRE CONVECTION OVEN. EXCEEDING 185°F, (85°C), SURFACE TEM­PERATURE CAN CAUSE PREMATURE COMPONENT FAILURE NOT COVERED UNDER
MANUFACTURERS WARRANTY. THE OVENS NEED 6" MINIMUM CLEARANCE ON THE
RIGHT SIDE BETWEEN SIMILAR OVENS OR OTHER COOKING EQUIPMENT. OPTIONAL
INSTALLATION KITS ARE AVAILABLE THAT REDUCE THE MINIMUM CLEARANCE
BETWEEN SIMILAR OVENS TO 1" AND BETWEEN OTHER EQUIPMENT TO 2". CONSULT
FACTORY.