Montague MI-3.5 CT 7 Installation Manual
INSTRUCTION MANUAL
MONTAGUE
Induction
Cookers
MODELS: MI-3.5 CT 7 MI2-7.0 CT Counter Models: MI-3.5 DI & MI2-7.0
DI Drop-In Models: MI4-14 Legend Models
These instructions should be read thoroughly before attempting installation.
Set up and installation should be performed by qualified installation personnel.
Keep area around appliances free and clear from combustibles.
PLEASE RETAIN THIS MANUAL
FOR FUTURE REFERENCE.
THE MONTAGUE COMPANY
1830 Stearman Avenue
P.O. BOX 4954
Hayward, CA 94540-4954
TEL: (510) 785-8822 FAX: (510) 785-3342
IMPORTANT
TABLE OF CONTENTS
Important (Cautions and Warnings) .............................................................. Page 1 - 3
Introduction .................................................................................................. Page 4
Installation .................................................................................................... Page 5 - 6
Operation ...................................................................................................... Page 7 - 8
Maintenance ................................................................................................. Page 9 - 10
Service .......................................................................................................... Page 11
SHIPPING DAMAGE CLAIM PROCEDURE
For your protection, please note that equipment in this shipment was carefully inspected and packed
by skilled personnel before leaving the factory. The transportation company assumed full
responsibility for safe delivery upon acceptance of this shipment.
If shipment arrives damaged:
1. VISIBLE LOSS OR DAMAGE - Be certain this is noted on freight bill or express receipt, and
signed by person making delivery.
2. FILE CLAIM FOR DAMAGES IMMEDIATELY - Regardless of the extent of damage.
3. CONCEALED LOSS OR DAMAGE - If damage is unnoticed until merchandise is unpacked,
notify transportation company or carrier immediately, and file “concealed damage” claim with
them. This should be done within fifteen (15) days of date that delivery was made to you. Be sure
to retain container for inspection.
We cannot assume responsibility for damage incurred in transit. We will, however, be glad to furnish you with
the necessary documents to support your claim.
IMPORTANT
ELECTRICAL WARNINGS
WARNING
THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL
ELECTRICAL EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD STARTUP AND
ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL.
WARNING
READ THIS MANUAL THOROUGHLY BEFORE OPERATING, INSTALLING OR PERFORMING
MAINTENANCE. ON THE EQUIPMENT.
WARNING
FAILURE TO FOLLOW ALL THE INSTRUCTIONS IN THIS MANUAL CAN CAUSE PROPERTY
DAMAGE, INJURY OR DEATH.
WARNING
IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE, CAN
CAUSE PROPERTY DAMAGE, INJURY, OR DEATH.
WARNING
ELECTRICAL CONNECTIONS SHOULD BE PERFORMED ONLY BY A CERTIFIED
PROFESSIONAL.
WARNING
ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE
PORTIONS OF THE NATIONAL ELECTRIC CODE AND/OR ALL LOCAL ELECTRIC CODES.
FAILURE TO COMPLY WITH THIS PROCEDURE CAN CAUSE PROPERTY DAMAGE, INJURY
OR DEATH.
WARNING
BEFORE CONNECTING THE UNIT TO THE ELECTRICAL SUPPLY, VERIFY THAT THE
ELECTRICAL AND GROUNDING CONNECTIONS COMPLY WITH THE APPLICABLE
PORTIONS OF THE NATIONAL ELECTRIC CODE AND/OR OTHER LOCAL ELECTRICAL
CODES. FAILURE TO COMPLY WITH THIS PROCEDURE CAN CAUSE PROPERTY DAMAGE,
INJURY OR DEATH.
1
IMPORTANT
WARNING
BEFORE CONNECTING THE UNIT TO THE ELECTRICAL SUPPLY, VERIFY THAT THE
ELECTRICAL CONNECTION AGREES WITH THE SPECIFICATIONS ON THE DATA PLATE.
FAILURE TO COMPLY WITH THIS PROCEDURE CAN CAUSE PROPERTY DAMAGE, INJURY
OR DEATH.
WARNING
UL73 GROUNDING INSTRUCTIONS: THIS APPLIANCE MUST BE CONNECTED TO A
GROUNDED, METAL, PERMANENT WIRING SYSTEM. OR AN EQUIPMENT-GROUNDING
CONDUCTOR MUST BE RUN WITH THE CIRCUIT CONDUCTORS AND CONNECTED TO THE
EQUIPMENT-GROUNDING TERMINAL OR LEAD ON THE APPLIANCE. FAILURE TO COMPLY
WITH THIS PROCEDURE CAN CAUSE PROPERTY DAMAGE, INJURY OR DEATH.
WARNING
BEFORE PERFORMING ANY SERVICE THAT INVOLVES ELECTRICAL CONNECTION OR
DISCONNECTION AND/OR EXPOSURE TO ELECTRICAL COMPONENTS, ALWAYS PERFORM
THE ELECTRICAL LOCKOUT/TAGOUT PROCEDURE. DISCONNECT ALL CIRCUITS. FAILURE
TO COMPLY WITH THIS PROCEDURE CAN CAUSE PROPERTY DAMAGE, INJURY OR
DEATH.
WARNING
BEFORE REMOVING ANY SHEET METAL PANELS OR SERVICING THIS EQUIPMENT,
ALWAYS PERFORM THE ELECTRICAL LOCKOUT/TAGOUT PROCEDURE. BE SURE ALL
CIRCUITS ARE DISCONNECTED. FAILURE TO COMPLY WITH THIS PROCEDURE CAN
CAUSE PROPERTY DAMAGE, INJURY OR DEATH.
WARNING
DO NOT OPERATE THIS EQUIPMENT WITHOUT PROPERLY PLACING AND SECURING ALL
COVERS AND ACCESS PANELS. FAILURE TO COMPLY WITH THIS PROCEDURE CAN
CAUSE PROPERTY DAMAGE, INJURY OR DEATH.
WARNING
DO NOT USE OR STORE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE
VICINITY OF THIS OR ANY OTHER APPLIANCE. FAILURE TO COMPLY CAN CAUSE
PROPERTY DAMAGE, INJURY OR DEATH.
WARNING
IN THE EVENT OF A POWER FAILURE, DO NOT ATTEMPT TO OPERATE THIS APPLIANCE.
FAILURE TO COMPLY CAN CAUSE PROPERTY DAMAGE, INJURY OR DEATH.
2
IMPORTANT
Studies have shown that the induction
element presents no danger. However, as
a precaution for persons using a
pacemaker, please keep 12 inches (30 cm)
from the unit while in operation.
The top is made from a strong non-porous
material. However, in case of cracking or
breakage, discontinue using the unit and
disconnect the power immediately.
Do not place spoons, kitchen utensils,
knives, pan lids, or other small objects on
the cooking surface while the unit is
operating, as they may also become hot.
The unit is equipped with a “small object
detector” to prevent small objects from
accidentally heating if placed on the
cooking surface of the unit by themselves.
However, if they are placed on the unit with
a suitable piece of cookware that activates
the unit, the smaller object may also
become hot.
Keep all magnetic security strips
commonly found on credit cards or a
driver’s license away from the unit, as the
unit’s magnetic field will damage the
information on the security strip.
Use a dedicated grounded electrical circuit
with the specified voltage rating provided
on the nameplate.
Use more oil (liquid) than you would with
conventional cook-tops.
Do not touch the cook surface after use.
Although the induction cook-top itself does
not produce heat, the surface will be hot
from the cookware and can cause burns.
Never place any objects in the air intake.
(Shock Hazard).
Never place this unit in or near water.
Never allow children to use any cook-top
without adult supervision.
If this unit malfunctions in any way, first
look at the troubleshooting section of this
manual, then contact the nearest service
facility for repair.
Do not operate unit if it has been damaged
or is malfunctioning in any way.
Do not place this unit near open flames,
electrical burners, or any other heat
source.
Never heat-sealed cans. This will cause
pressure to build up in the can and may
cause an explosion.
Let the cook-top cool before moving.
Never move while in use.
Place the induction range on a flat,
horizontal surface, with at least 4 inches of
space from any other object.
Insure proper ventilation for the cooling
fans. Do not block air intakes or exhausts.
Use cookware at least 4.5 inches in
diameter.
Do not place empty cookware on cooking
surfaces while the range is turned on.
Exceptions are for stir-fry and searing
meat.
Unplug when not in use.
Never store objects on top of your
induction range.
Do not use this product for any purpose
other than cooking.
Unplug and let cool before cleaning and
moving.
Do not spray controls or outside of unit
with liquid or cleaning agents.
Do not operate unattended.
3
Loading...