Montague 2EK15A Installation Manual

INSTRUCTION MANUAL

addendum

MONTAGUE SLEK

Electric Convection Ovens

with

Solid State Electronic Controls

MODELS:

SLEK15 (AH, AP) and SLEK2-15 (AH, AP)

This manual is meant as a supplement to the Electric Vectaire manual. The contents
herein describe the function and operation of the Solid State Electronic Controls. For

information on Electric Vectaire Oven Installation, operation, maintenance, service

and parts, refer to the Electric Vectaire manual part no. 4519-5.

These instructions should be read thoroughly before attempting installation.

Set up and installation should be performed by qualified installation personnel.

Keep area around appliances free and clear from combustibles.

PLEASE RETAIN THIS MANUAL

FOR FUTURE REFERENCE.

THE MONTAGUE COMPANY

1830 Stearman Avenue P.O. BOX 4954

HAYWARD,CA 94540-4954

TEL: [phone] FAX: [phone]

CONTENTS

INTRODUCTION, INSTALLATION & CAUTIONS 4
OPERATION (Cooking with Solid State Controls) 5-9
WIRE DIAGRAMS 10

IMPORTANT

WARNING:
Improper installation, adjustment,
alteration, service or maintenance
can cause property damage, injury
or death. Read the operating and
maintenance instructions
thoroughly before installing or

FOR YOUR SAFETY:

Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other
appliance.

servicing this equipment.

INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE USER SMELLS GAS

MUST BE POSTED IN A PROMINENT LOCATION. THIS INFORMATION MAY BE

OBTAINED BY CONSULTING THE LOCAL GAS SUPPLIER.

SHIPPING DAMAGE CLAIM PROCEDURE

For your protection, please note that equipment in this shipment was carefully inspected and packed by
skilled personnel before leaving the factory. The transportation company assumed full responsibility
for safe delivery upon acceptance of this shipment.

If shipment arrives damaged:

1. VISIBLE LOSS OR DAMAGE—Be certain this is noted on freight bill or express receipt, and
signed by person making delivery.

2. FILE CLAIM FOR DAMAGES IMMEDIATELY—Regardless of the extent of damage.

3. CONCEALED LOSS OR DAMAGE—If damage is unnoticed until merchandise is unpacked,
notify transportation company or carrier immediately, and file “concealed damage” claim with
them. This should be done within fifteen (15) days of date that delivery was made to you. Be sure
to retain container for inspection.

We cannot assume responsibility for damage incurred in transit. We will, however, be glad to furnish
you with necessary documents to support your claim.

2

3 4

INTRODUCTION

The SLEK series Vectaire electric convection ovens are very similar to the Vectaire ovens
Montague has produced for years. The most significant difference is that the solid-state electronic
controls are used instead of the electromechanical ones commonly used. The result is the most
accurate, responsive and predictable ovens we have ever offered with the recognized
dependability of solid-state components.

This special manual is meant to be used as a supplement to the main ―Vectaire Electric
Convection Ovens‖ instruction manual, P/N: 4519-5, which should be referenced first for general
instructions.

INSTALLATION

Refer to the installation instructions in manual 4519-5 covering shipping damage, assembly,
leveling, and electrical connection. In addition, since solid-state components have a very short life
span when exposed to temperatures above 185°F (85°C), certain installation precautions are
necessary. The SL ovens have been designed to operate well below this temperature when
installed properly, and the following cautions are observed.

Caution

1. Do not obstruct the air out of the vent holes at the top of the oven, or the flow of fresh room air
to the oven bottom or lower front portion of the burner access cover.

2. Do not mount the oven on a solid curb unless it has been modified at the factory for this type of
operation.

3. When stacking ovens, never reverse the top and bottom ovens.

4. Never stack an SLEK convection type oven with a standard Vectaire, or any other type of oven
without first consulting the factory. Certain ovens are not compatible, or a stacking kit may be
required.

Special Caution

DO NOT PLACE HIGH HEAT PRODUCING EQUIPMENT ADJACENT TO THE RIGHT SIDE OF
AN ―SLEK‖ VECTAIRE CONVECTION OVEN. EXCEEDING 185°F, (85°C), SURFACE
TEMPERATURE CAN CAUSE PREMATURE COMPONENT FAILURE NOT COVERED UNDER
MANUFACTURERS WARRANTY. THE OVENS NEED 6‖ MINIMUM CLEARANCE ON THE
RIGHT SIDE BETWEEN SIMILAR OVENS OR OTHER COOKING EQUIPMENT. OPTIONAL
INSTALLATION KITS ARE AVAILABLE THAT REDUCE THE MINIMUM CLEARANCE BETWEEN
SIMILAR OVENS TO 1‖ AND BETWEEN OTHER EQUIPMENT TO 2‖. CONSULT FACTORY.