To avoid hearing damage, make sure that the volume on your music
player is turned down before connecting your headphones. After
placing headphones in your ears, gradually turn up the volume
until you reach a comfortable listening level.
Noise levels are measured in decibels (dB), exposure to any noise
at or above 85 dB can cause gradual hearing loss.
Monitor your use; hearing loss is a function of loudness versus time.
The louder it is, the less time you can be exposed to it. The softer it is,
the more time you can listen to it. Refer to the chart* below.
This decibel (dB) table compares some common sounds and shows
unprotected exposure
recommended for
sounds between
90-100 dB
Power Saw, Drill/
Jackhammer
110Regular exposure to
sound over 100 dB of
more than 1 minute risks
permanent hearing loss
Rock Concerts (varies)110-140Threshold of pain begins
around 125dB
*Chart information obtained from http://www.nidcd.nih.gov/health/education/teachers/common_sounds.asp
“…a typical person can safely listen to an iPod for 4.6 hours per day at 70% volume.”
“…knowing the levels one is listening to music at, and for how long
is extremely important.”
From http://www.cbc.ca/health/story/2006/10/19/music-earphones.html
Get the most out of your equipment and enjoy great audio performance even
at safe levels. Our headphones will allow you to hear more details at lower volume
levels than ever before.
Physiology of the Ear and Hearing
For additional information on what loud
noises do to your ear and chart reference
http://www.abelard.org/hear/hear.php#loud-music
4
ENGLISH
5
ENGLISH
Use Responsibly
Do not use headphones when it’s unsafe to do so – while operating a vehicle,
crossing streets, or during any activity or in an environment where your full
attention to your surroundings is required.
It ‘s dangerous to drive while wearing headphones, and in many places,
illegal because it decreases your chances of hearing life-saving sounds
outside of your vehicle, such as another car’s horn and emergency
vehicle sirens.
Please avoid wearing your headphones while driving. Use one of Monster’s
FM transmitters to listen to your mobile media devices instead.
Learn how to establish a safe listening level and review other important
safety guidelines from the Consumer Electronics Association at www.ce.org
and the Deafness Research Foundation at www.drf.org.
Connect, Talk and Control
The Beats™ Solo™ HD headphone cable features a built-in Monster
ControlTalk™ for use with your music phone and newer iPod.*
The ControlTalk has a call answer button and microphone so
you can easily switch between listening to music and talking
on your phone. It also features music and video playback control
for iPod, iPhone and iPad.
To connect, plug the end of the Beats headphone cable that is
closest to the ControlTalk into the bottom of the left earcup and
the other end into 1/8" (3.5mm) stereo plug on your music player.
*The remote and mic are supported only by iPod nano (4th and 5th generation), iPod classic (120GB,
160GB only), iPod touch (2nd and 3rd generation), iPhone 3GS, and iPad. The remote is supported
by iPod shuffle (3rd generation). Audio is supported by all iPod models. Requires latest iPod software.
Support for Blackberry
®
varies by model. Subject to change.
6
ENGLISH
7
ENGLISH
Using ControlTalk
Answer or end a call: Press and release the center button once
to answer. Repeat to end the call.
Decline an incoming call: Press and hold the center button
for two seconds, then release. There will be two beeps when
you let go to indicate successful operation.
Using call waiting: To switch to an incoming call and put
an in-progress call on hold, press and release the center button.
Repeat to switch back to the previous call and put the newer call
on hold. To switch to an incoming call and end an in-progress call,
press and hold the center button for two seconds. You will hear two
low beeps when you let go to indicate successful operation.
Play or pause a song or video: Press and release the center button.
Repeat to resume.
Skip to the next or previous song or chapter: Press and release
the center button twice quickly to skip forward. Press and release
three times quickly to skip back.
Scan forward or backward through a song or video: In quick
succession, press and release, then press and hold the center button
to scan forward. In quick succession, press and release twice, then
press and hold the center button to scan backward. Release when
you want to stop scanning.
™
Control volume: Press the (+) button to increase volume.
Press the (–) button to decrease volume.
Functionality will vary by device.
Listen
Turn down the volume on your music player before putting on
Beats™ Solo™ HD headphones.
Note the “L” and “R” markings above the inside of each earcup.
“L” is for the left ear. “R” is for the right ear.
Fold
Remove your Beats cable. Note the two folding
hinges on the Beats headband. Fold one side,
then the other.
Apply pressure to the hinge, not the earcup,
when folding.
Excessive listening levels can cause
permanent hearing damage. Avoid
loud listening, especially for extended
periods of time.
Loading...
+ 9 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.