Monsher TEXNO 60 B User manual

Инструкция по эксплуатации

User manual

Встраиваемая кухонная вытяжка

Built in Cooker Hood

TEXNO 60

2

English

TECHNICAL DETAILS type: TEXNO 60

Rated voltage 230 В - 50

general power

Engine power

Lighting power

Max. performance 650 м3/h

Equipment class second
Operation mode continuous, under control

121W

115 W

2 x 3 W

3English

Closely follow the instructions set out in this manual. All responsibility, for any
eventual inconveniences, damages or fires caused by not complying with the
instructions in this manual, is declined. The hood is conceived for the suction of
cooking fumes and steam and is destined only for domestic use.

The hood can look different to that illustrated in the drawings in this booklet.
The instructions for use, maintenance and installation, however, remain the same.

It is important to conserve this booklet for consultation at any moment. In the case of
sale, cession or move, make sure it is together with the product.

Read the instructions carefully: there is important information about installation, use
and safety.

Do not carry out electrical or mechanical variations on the product or on the discharge
conduits.

Before proceeding with the installation of the appliance verify that there are no damaged
all components. Otherwise contact your dealer and do not proceed with the installation.

NOTE: the elements marked with the symbol “(*)” are optional accessories
supplied only with some models or elements to purchase, not supplied!

WARNING: Do not connect the appliance to the mains until the installation is fully
complete. Before any cleaning or maintenance operation, disconnect hood from the
mains by removing the plug or disconnecting the mains electrical supply.

Always wear work gloves for all installation and maintenance operations.

The appliance is not intended for use by children or persons with impaired physical,
sensorial or mental faculties, or if lacking in experience or knowledge, unless they
are under supervision or have been trained in the use of the appliance by a person
responsible for their safety.

This appliance is designed to be operated by adults, children should be monitored
to ensure that they do not play with the appliance.

This appliance is designed to be operated by adults. Children should not be allowed
to tamper with the controls or play with the appliance.

Never use the hood without effectively mounted grating!

4

The hood must NEVER be used as a support surface unless specifically indicated.

The premises where the appliance is installed must be sufficiently ventilated, when
the kitchen hood is used together with other gas combustion devices or other fuels.

The ducting system for this appliance must not be connected to any existing
ventilation system which is being used for any other purpose such as discharging
exhaust fumes from appliances burning gas or other fuels.

The flaming of foods beneath the hood itself is severely prohibited.

The use of exposed flames is detrimental to the filters and may cause a fire risk,
and must therefore be avoided in all circumstances.

Any frying must be done with care in order to make sure that the oil does not
overheat and ignite.

Accessible parts of the hood may became hot when used with cooking appliance.

With regards to the technical and safety measures to be adopted for fume
discharging it is important to closely follow the regulations provided by the local
authorities.

The hood must be regularly cleaned on both the inside and outside (AT LEAST
ONCE A MONTH).

This must be completed in accordance with the maintenance instructions provided
in this manual). Failure to follow the instructions provided in this user guide regarding
the cleaning of the hood and filters will lead to the risk of fires.

Do not use or leave the hood without the lamp correctly mounted due to the
possible risk of electric shocks.

We will not accept any responsibility for any faults, damage or fires caused to the
appliance as a result of the nonobservance of the instructions included in this manual.

This appliance is marked according to the European directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the
environment and human health, which could otherwise be caused by inappropriate
waste handling of this product.

The symbol on the product, or on the documents accompanying the product,
indicates that this appliance may not be treated as household waste. Instead it
should be taken to the appropriate collection point for the recycling of electrical

English

5English

and electronic equipment. Disposal must be carried out in accordance with local
environmental regulations for waste disposal.

For further detailed information regarding the process, collection and recycling
of this product, please contact the appropriate department of your local authorities
or the local department for household waste or the shop where you purchased this
product.

Appliance designed, tested and manufactured according to:

; Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233.

; Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/IEC 60704-1; EN/

IEC 60704-2-13; ISO 3741; EN 50564; IEC 62301.

; EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC

61000-3-3.

Suggestions for a correct use in order to reduce the environmental impact:
Switch ON the hood at minimum speed when you start cooking and kept it running
for few minutes after cooking is finished. Increase the speed only in case of large
amount of smoke and vapour and use boost speed(s) only in extreme situations.
Replace the charcoal filter(s) when necessary to maintain a good odour reduction
efficiency. Clean the grease filter(s) when necessary to maintain a good grease
filter efficiency. Use the maximum diameter of the ducting system indicated in this
manual to optimize efficiency and minimize noise.

Additional Installation Specifications:

Use only the fixing screws supplied with the product for installation or, if not
supplied, purchase the correct screws type.

Use the correct length for the screws which are identified in the Installation Guide.

In case of doubt, consult an authorised service assistance centre or similar
qualified person.

WARNING! Failure to install the screws or fixing device in accordance with these
instructions may result in electrical hazards.

6

English

1

3

2

4

5

6

7English

7

8

10

9

11

8

English

12

14

13

15

16 17 18

9English

10

English

USE

The hood is designed to be used either for exhausting or filter version.

Ducting version

In this case the fumes are conveyed outside of the building by means of a special
pipe connected with the connection ring located on top of the hood.

Attention! The exhausting pipe is not supplied and must be purchased apart.

Diameter of the exhausting pipe must be equal to that of the connection ring.

In the horizontal runs the exhausting pipe must be slightly slanted (about 10°)
and directed upwards to vent the air easily from the room to the outside.

Attention! If the hood is supplied with active charcoal filter, then it must be
removed.

Connect the hood and discharge holes on the walls with a diameter equivalent
to the air outlet (connection flange).

Using the tubes and discharge holes on walls with smaller dimensions will cause
a diminution of the suction performance and a drastic increase in noise.

Any responsibility in the matter is therefore declined.

Use a duct of the minimum indispensible length.
Use a duct with as few elbows as possible (maximum elbow angle: 90°).
Avoid drastic changes in the duct cross-section.
Use a duct as smooth as possible inside.
The duct must be made of certified material.

Filter version

One active charcoal filter is needed for this and can be obtained from your usual
retailer.

The filter removes the grease and smells from the extracted air before sending
it back into the room through the upper outlet grid.

11English

INSTALLATION

The minimum distance between the supporting surface for the cooking
equipment on the hob and the lowest part of the range hood must be not less than
45 cm from electric cookers and 50 cm from gas or mixed cookers.

If the instructions for installation for the gas hob specify a greater distance, this
must be adhered to.

Electrical connection

The mains power supply must correspond to the rating indicated on the plate
situated inside the hood. If provided with a plug connect the hood to a socket in
compliance with current regulations and positioned in an accessible area, after
installation. If it not fitted with a plug (direct mains connection) or if the plug is
not located in an accessible area, after installation, apply a double pole switch
in accordance with standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in accordance with
installation instructions.

Warning! Before re-connecting the hood circuit to the mains supply and checking
the efficient function, always check that the mains cable is correctly assembled.
The hood is provided with a special power cable ; if the cable is damaged, request
a new one from Technical Service.

Mounting

Very heavy product; hood handling and installation must be carried out by at
least two persons.

Before beginning installation:

; Check that the product purchased is of a suitable size for the chosen installation

area.

; Remove the charcoal (*) filter/s if supplied (see also relative paragraph). This/

these is/are to be mounted only if you want lo use the hood in the filtering
version.

; Check (for transport reasons) that there is no other supplied material inside

the hood (e.g. packets with screws (*), guarantees (*), etc.), eventually removing
them and keeping them.