Monoprice SS-6, SS-4, SSVC-4.1 Quick Install Manual

SS-6 Premium 6-Channel Speaker Selector

P/N 38158

Quick Install Guide

INTRODUCTION

The SS-6 Speaker Selector is a resistor-based, impedance matching speaker selector used

for connecting up to six pairs of 4-ohm or 8-ohm speakers, while maintaining a safe

impedance load for your amplifier or receiver. Each pair of speakers can be independently

turned on or off using push buttons on the front panel, with no need for worrying about

amplifier loading.

FEATURES

 Connect and safely control multiple speaker pairs with a single amplifier
 Automatic impedance protection circuitry
 100 watts RMS per channel power capacity
 4.6-ohm minimum amplifier impedance with six 4-ohm speakers selected, 5.3-ohm

minimum with 8-ohm speakers

 Supports 12-16 AWG speaker wire
 Individual zone on/off buttons
 Heavy-duty screw-type connectors
 Isolated left/right circuit grounds provide safe connection for amplifiers with

floating grounds or bridged configurations

 Accurate, noise-free switching

1

INSTALLATION

1. Refer to the manuals for your amplifier and speakers to determine the correct wire

gauge to use with the speaker selector.

2. Lay out all wire runs from each speaker location and your amplifier to the selector.

3. Remove the connector blocks from the selector and connect

them to the wires, as shown in the image to the right.

Carefully inspect the connections for any stray wire strands.

4. Insert the connector blocks back into the selector.

SAMPLE CONNECTION DIAGRAM

The speakers on the right have inline volume controls.

2