USER’S MANUAL
PID 10529
V1.0
May 8, 2013
1
TABLE OF CONTENTS
1 FEATURES .................................................................................................................. 3
2 SPECIFICATIONS ....................................................................................................... 3
3 INSTALLATION ............................................................................................................ 4
4 SAFETY WARNINGS ................................................................................................... 5
2
1. FEATURES
• Includes three protected power outlets
• Includes coaxial protection for use with satelli te antenna or cable TV lines
• Provides superior surge protection and EMI/RFI filtration
• Uses X3 Metal Oxide Varistor technology
• Includes thermal fuses to protect against excessive heat and fire
• 90° rotating design for the c oax i al connec ti on and the lower power outlet
• LED indicates when the surge function is operating properly
2. SPECIFICATIONS
Electrical Rating 15A, 120V, 60Hz, 1800 Watts
Surge Lines Protected 3-Line (L-N, L-G, N-G)
UL Clamping Voltage L-N 400V, L-G 400V, N-G 400V
Surge Energy Joule Rating 1080 Joules
Maximum Spike Current 72,000 Amps (3 Line Total)
Response Time < 1 Nanosecond
Max. Spike Voltage 6 KV
EMI/RFI Noise Filter Yes
Frequency 150KHz~100MHz
Attenuation Up to 40dB
DSS/Coax Cable Line Protection Yes
Surge Arrestor Gas Tube
Breakdown Voltage < 75V
Insertion Loss < 0.1 dB
3
3. INSTALLATION
For long-term use it is best to secure the power tap to the wall outlet. To do so, perform the
following steps:
1. Insert a small flat screwdriver into the slot at the
bottom of the faceplate and carefully pry the
faceplate loose from the power tap.
2. Remove the center screw from the faceplate of
the wall outlet. Leave the faceplate in
place.
3. Using the included security screw and a Philips
screwdriver, secure the power tap to the wall
outlet. Tighten, but do not overtighten.
4. Align the tabs on the faceplate and snap it back into
place on the power tap.
4
4. SAFETY WARNINGS
• This product is for indoor, dry use only. It should not be used for aquariums or other
water-related devices.
• The power tap must be plugged directly into a wall outlet. Do not plug it into another
surge protector or power strip.
• Do not exceed the rated electrical levels. Doing so could cause the wiring in the wall
outlet to overheat, which could start a fire.
• This device is intended to protect your electrical equipment from voltage and current
spikes and other anomalies. It is not a lightning arrestor and will not provide full
protection in the event of a lightning strike.
5
Loading...