Monoprice MP True User Manual

Monoprice MP True Wireless Speakers - Black (Pair)

User Guide

P/N 33824

Box Content

1. 2* True Wireless Speaker

2. 1 * Charging Cable

3. 1* Audio Cables

4. 1* User Manual

Product Overview

Note:
The Master Speaker connects to your device and will always be the left speaker. This will be
shown as a solid white “L” illuminated on the front of the speaker beneath the power button.

To clear the pairing settings, press and hold the “ Volume -” and “Volume +” buttons together
until they signal the pairing was reset with a short “beep.”

Power Button

Press and hold for 3 seconds to power on/off the speaker.

Bluetooth Button

Press and hold this button for 2 seconds to enter Bluetooth paring mode. The Speakers will
“beep” after a successful connection and disconnection.

Volume- /Prev button
Press once to decrease volume.
Press and hold to navigate to the previous track.

Volume+/Next Button

Press once to increase volume.

Press and hold to navigate to the next track.

Mode Button

Use this button to toggle between Bluetooth/AUX/TF card modes.

Play/Pause/Phone Button

Press the button to play / pause the music.
Press to answer / end or press and hold to decline a phone call.

Press and hold for 3 seconds to activate virtual assistants (if applicable) when in Bluetooth mode.

Mode Button

Use this button to toggle between Bluetooth/AUX/TF card modes.

Power on/off Indicator
Solid Green: The speaker is powered on or it’s fully charged.
Flashing Red: Battery low.
Solid Red: Currently charging.

Mode Indicator

Solid Blue: The speaker is in bluetooth mode.
Rapidly Flashing Blue: Waiting to be paired.
Slowly Flashing Blue: Bluetooth paired successfully.
Solid Green: Aux Mode- the music is paused.
Flash Green: Aux Mode- Music is playing.
Solid orange: TF Card Mode.
Flash Orange: TF Card Mode- Music is playing

L&R Indicator

Solid “L”: Paired ‘Master’ Left Speaker.
Solid “R”: Paired ‘Slave’ Right Speaker.

If both indicator lights are off, then only the Master is in use.
The indicator lights will both flash repeatedly until the speakers are successfully paired.
(‘Master’ –L with ‘Slave’-R, and ‘Master’ –L with device)

AUX IN Port

Use this port to connect an external media device via the AUX cord（’Master’ only）.

Charging Port

Insert the power cord into the Micro-USB port of the device (Use with 5V/1A adapter).
Charging begins automatically even if the device is powered off. (USB power adapter is not
included)

TF Card Port

Insert the TF card into this slot to play stored media (Master only).

Reset port

Insert a small pin into this port to reset the speaker. This is only for use when the speaker
becomes unresponsive or inoperable. Do not use under normal operating conditions.

INSTRUCTIONS

True Wireless Function

Power on the two speakers together. They will connect to each other automatically within 3

seconds (signified by a beeping alert). They will automatically be separated into Left and Right

Channels.

NOTES: The Master with illuminated “L” ( Left Channel ) can be paired with your phone or other

BT devices. The Slave with illuminated “R” ( Right Channel ) just can be connected to the Master.

Bluetooth Mode

1. Press and hold the bluetooth button for 2 seconds to enter Bluetooth pairing mode. The

speakers will “beep” and the indicator light will flash blue.

2. Bluetooth Pairing Mode will automatically be canceled (signaled by a beep) after 3 minutes.

To re-enter pairing mode, simply begin again at step #1.

3. Ensure bluetooth is enabled on the device you wish to pair with the speaker.

4. Keep your device within 3 feet of the speaker, in the Bluetooth settings of you device pair

with “MP-TWSPK.”

5. The speaker will remember this device when powered off and back on.

6. Incoming calls will override music and other media with an incoming call voice alert, simply

press the “Play/Pause” button to answer/end or press and hold for 2 seconds to decline the

call.

Notes: Only the Master can talk, when you answer the phone.

7. When in BT mode, press the “Play/Pause” button twice quickly to activate virtual assistants

(if applicable).

8. To switch media devices, simply press and hold the bluetooth button on the Master to

disconnect the paired device, then re-press and hold the button to enter pairing mode and

pair to the other device.

Aux Mode

1. Insert the AUX cord into the audio input port of the ‘Master’ speaker to automatically switch

the speakers to AUX mode.

2. The indicator light will flash green when playing music, it will be solid green when the music

is paused.

TF Card Mode

1. Insert a Micro SD card to the slot of the ‘Master’ speaker to automatically switch the

speakers to TF Card mode.

2. The indicator will flash orange when playing music. It will be solid orange when the music is

paused.

Notes: Simply press the Mode button to switch between BT/AUX/TF Card modes.

FEATURES

1. Advanced BT Truewireless Chipset, Real Wireless Stereo Sound in Rich Quality

2. Bluetooth, AUX and TF Card Connection Capability

3. IPX6 Waterproof

4. 10hours of Extended Playtime(at 50% volume)

5. Handsfree Call with High-sensitive Microphone

6. SIRI and S-Voice Supported

7. Auto idle shutoff in 40 minutes to Save Power

SPECIFICATIONS

1. Bluetooth Version: 5.0

2. Output Power: 8W

3. Battery Capacity: 2600mAh

4. Speaker Spec: 52mm

5. Charging Voltage: DC 5V

6. Frequency Response: 60Hz-20 kHz

7. THD：≤0.1%

8. SNR: ≥ 80DB

9. SIZE:φ82mm×110mm

Troubleshooting

Speaker will not turn on

*If currently charging, ensure your speaker is connected to a working Power Adapter.

*If operating on battery power, the battery may be in protection mode or discharged. Connect to

a power adapter to restore the battery to operational mode.

Cannot pair or connect the speaker to my Bluetooth device

*Ensure your speaker is discoverable (BT status indicator rapidly flashes blue).

*Ensure Bluetooth is activated on your device and that you have selected the correct device

name in the Bluetooth device list, and the connection has been confirmed by your device.

*Your Bluetooth device may be out of range. Try moving it closer to the speaker.

*If possible, turn off all other nearby Bluetooth devices or disable their Bluetooth functionality.

*Turn the speaker off and back on, and pair your device and speaker again.

The speaker indicates a connection, but is not playing music

*Ensure the device you want to hear is connected to the speaker and playing audio.

*Ensure the speaker is not muted and the speaker volume is turned up.

*Turn up the volume on your device.

*Your device may be out of range. Try moving it closer to the speaker.

Move your device away from any device that generates electromagnetic interference, such as

another BT device, cordless phone, micro- wave oven, or wireless router.

*Turn off or disable Bluetooth functionality on all other nearby paired devices and reconnect the

device you want to hear.

*Turn the speaker off and back on.

Proper Use

1. Please charge your new speakers for at least two hours before first use.

2. To prevent damage and risk of electrical shock, do not expose this device to dust,

vibration, rain, water or liquids of any kind.

3. Do not place device in close proximity to open flames or extreme heat sources. Always

place your device on level, flat, and stable surfaces.

4. Avoid placing items on top of the speakers.

5. Do not use excessive force when pressing buttons or handling speakers.

6. To clean your speakers, use a dry, soft cloth or slightly damped cloth without any

corrosive solvent or cleaning agent.

REGULATORY COMPLIANCE

Notice for FCC

This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Modifying the equipment without Monoprice’s authorization may result in the equipment no

longer complying with FCC requirements for Class B digital devices. In that event, your right to

use the equipment may be limited by FCC regulations, and you may be required to correct any

interference to radio or television communications at your own expense.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Radio Notice for FCC

Caution

This FCC Part 15 radio device operates on a non-interference basis with other devices operating

at this frequency. Any changes or modification to said product not expressly approved by

Monoprice, including the use of non-approved antennas, could void the user’s authority to

operate this device.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

The Bluetooth® word mark and logos are registered trademarks of Bluetooth SIG, Inc.