Monoprice MP38542 User Manual
FCC ID: 2ADDH-MP38542
NOTE : Please tear the stickers underneath the earphones before using.
Turn on the left and right earphones by pressing and holding the MFB on both
earphones for about 1 second . The earphones will automatically enter pairing
mode . Search the list of available Bluetooth devices for the name “TWEPlus”,
then select it to connect . The earphones will give the following voice prompts:
Power on Pairing (Right earphone) Connect (Right earphone)
Power O
1. Put the earphones into the charging box , it will power o automatically
and the white LED will light up means the earphones are charging. If you put
either one earphone into the charging box separately , the other one will
automatically enter pairing mode.
2.When the earphone is on , press and hold the MFB for 4 seconds.
Once paired, you can wirelessly stream audio from your device to your
earphones. Music will automatically pause when you receive an
incoming phone call and will resume once the call has ended.
Power On and Pairing the Single Earphone
1.After pairing both earphones , if you put the left earphone back into the
charging box for charging , the right earphone will still connect with your
device. If the left earphone full charged , you take it out of charging box ,
it will connect with the right earphone automatically , then two earphones
are back to stereo sound.
2.After pairing both earphones , if you put the right earphone back to the
charging box for charging , the left earphone will stop playing and enter
pairing mode with voice prompt “Pairing” . The pairing name is still
“TWEPlus” in your device , please select to connect. Then there is voice
prompt “Connected” .
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
This device may not cause harmful interference
This device must accept any interference received, including interference that may
cause undesired operation.
Loading...