Monoprice MP34710 User Manual

User’s Manual
SB-100
Accessories
1
2
Personal.
34678
9
1
2 3
4
1.DISPLAY
2.OPTICAL
3.COAXIAL
10
1
13
3
5
8
10
11
12
2
PAI R
LUM
4
6
7
-10
9
TREBLE-
BASS- BASS+
MUSIC
NEWS
INPUT
RESET
TREBLE+
MOVIE
3D
+10
14
15
16
17
23
18
19
20
21
22
1.STANDBY:Standby mode for power on/off.
2. PAIR: Connect or disconnect to the pairing device.
(Press the button more than 2 seconds)
3. LUM: Indicator on/off. (This button can not work under standby status)
4. Loop playback. (Only work under USB and mode.)
5. VOL+: Volume increase adiustment button.
6. Pre button: Previous track.
(Only work under and BT mode.)
7. VOL-: Volume Downward Adiustment Button.
8. -10: Backwards ten songs. (Only work under USB) mode.
9. TREBLE-: Treble Decrease Button.
10. BASS-: Bass Decrease Button.
11. MUSIC: Select the MUSIC EQ effect.
12. NEWS: Select the MUSIC EQ effect.
13. MUTE mode.
14. INPUT: AUX/USB/BT/OPT/COA selecion
15. RESET: Reset all soundbar volume levels and switch EQ back to Music setting. Press and hold button for 2 seconds
16. Stop button: Press to stop. (Only work under USB mode.)
17. Next button: Next track. (Only work under USB and BT mode.)
18. +10: Forwards ten songs. (Only work under USB mode.)
19. TREBLE+: Treble lncrease Button.
20. BOSS+: Bass lncrease Button.
21. MOVIE: Select the MOVIE EQ effect.
22. 3D: Select the 3D EQ effect.
23.Play/Pause
(Only work under USB and BT mode.)
11
12
T
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditi
ons: (1) This device may not cause harmful interference, and (2) this device must accept any interfer
ence received, including interference that may cause undesired operation. Note: This equipment has bee
n tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide
reasonable protection against harmful interference i
n a residential installation. This
equipment generates, uses and can radiate radio frequency energy a
nd, if not installed and
used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, wh
ich can be determined by turning the equipment off and on, the
user is encouraged to try to correct t
he interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on
a circuit different from that to which the receiver is connected. —Consult the dealer or an experience
d radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications
not expressly approved by the party responsible for compliance. such modifications could void the use
r's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requ
irement. This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolle
d environment. This device and its antenna(s) must not be co-located or
conjunction with any other an
tenna or transmitter.
1
Loading...