User Guide
33828
Monoprice HarmonyMini Bluetooth Wireless Speaker
P/N
PACKAGE CONTENTS
FUNCTIONS PANEL
1. Bluetooth Speaker x 1 pc
2. Micro USB cable x 1 pc
3. 3.5mm Audio cable x 1 pc
4. User manual x 1 pc
1. : Power ON/Power OFF
BLUETOOTH MODE:
2. : Volume Down/ Last Track
3. : Volume Up/Next Track
4. : Play/Pause/Hands Free
5. : Hands Free/Switch Modes
6. : DC 5V IN Charging Port
7. : Aux in
8. ：SD card slot
1. Press and hold to turn the speaker ON/OFF. The speaker will emit tones. The LED be
flash blue slowly.
2. Turn on the BT function of your mobile device and in your device’s Bluetooth settings pair
with “MP33828.” When connected, the LED indicator will turn to solid blue. Press and hold
to disconnect Bluetooth.
3. Press to Pause or Play media.
AUX IN MODE:
Note: Hands free function is not available in AUX mode.
4. Press to decrease volume; press and hold it to play the last track.
5. Press to increase volume; press and hold it to play the next track.
6. When there is an incoming call, press to answer it, then press it again to hang up.
Press and hold it to reject the incoming call.
1. After the speaker is turned on, you can connect your mobile device to the speaker via the
AUX port. When in AUX mode, the LED indicator light will be solid blue.
2. Press button to Pause or Play media
3. Press button to decrease volume; turn to last track is not available
4. Press button to increase volume; turn to next track is not available
5. Press and hold to switch to Bluetooth mode.
CHARGING:
CAUTION:
The speaker has a built-in rechargeable battery. Before using the speaker for the first time,
please fully charge the battery via the USB cable. When charging, the LED light next to the
charging port will be red, and it will turn off when the speaker is full charged. It will take 3-4
hours to fully charge the speaker’s battery if fully depleted.
Do not open the speaker’s housing or alter/attempt to fix internal components. This will put
you at risk for electric shock or burns. Do not expose the speaker to excessive amounts of
heat and do not store or operate near an open flame.
SPECIFICATIONS
BT Chipset
BT version
BT profile
BT Distance
Driver power
Driver size
Impedance
Response frequency
JL AC4603A
V2.1+EDR
A2DP, AVRCP, HFP
>=10m
5W x2
1.5” x2
4Ω
80Hz --20kHz
Signal Noise
THD
Built in Microphone
Charging indicator
Buttons and controls Power
≥ 65dB
<1%
yes
Red
Last Track/V-
Next Track/V+
Play/Pause
Hands free/mode switching
Connection jacks
Available modes
Output power (at 10%
THD)
Input
Battery type
Battery capacity
Battery weight
Playback time
BT/Aux in
5W x2
5V, 1A
lithium battery
1800mAh /3.7V
42.9g
Approx. 7 hours @ 60% volume
Charging time
Unit size
Unit weight
Accessories
AC/DC input jack
USB output jack
3-4h
160 x 53 x 62mm
400g
USB charging cable, Aux in cable
DC 5V input jack
Micro USB
Aux in jack
REGULATORY COMPLIANCE
Notice for FCC
yes
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Modifying the equipment without Monoprice’s authorization may result in the equipment
no longer complying with FCC requirements for Class B digital devices. In that event, your
right to use the equipment may be limited by FCC regulations, and you may be required to
correct any interference to radio or television communications at your own expense.
Radio Notice for FCC
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This FCC Part 15 radio device operates on a non-interference basis with other devices
operating at this frequency. Any changes or modification to said product not expressly
approved by Monoprice, including the use of non-approved antennas, could void the user’s
authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
The Bluetooth® word mark and logos are registered trademarks of Bluetooth SIG, Inc.
Loading...