Monoprice 8587 User Manual

Monoprice Adjustable Tilt Swivel Plat Panel Wall Mount Model: PLB-110B-R (PID#8587/8588)

VESA Compliant up to 750x450 Max Weight: 175lbs

InstallationInstruction

English

UNPACKING INSTRUCTIONS

Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.

Check package contents against the Supplied Parts List in the next page to assure that all components were received

undamaged. Do not use damaged or defective parts.

Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

Install and operate this device with care. Please read this instruction before beginning the installation, and carefully follow all instructions contained herein. Use proper safety equipment during installation.

Please call a qualified installation contractor for help if you:

If you don't understand these directions or have any doubts about the safety of the installation.

If you are uncertain about the nature of your wall, consult a qualified installation contractor.

Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby disclaim any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

CAUTION!

This TV mount must be securely attached to the vertical wall. If the mount

WARNING

is not properly installed it may fall, resulting in possible injury and/or damage.

Tools Required

5/32"(4mm) Drill Bit Phillips Screwdriver

3/8"(10mm) Masonry Bit Stud Finder

Wrench or Socket Set Carpenter's Level

Note: The mounting components and hardware supplied in this package are not designed for installations to

walls with steel studs or to cinder block walls. If the hardware you need for your installation is not included, please consult your local hardware store for proper mounting hardware for the application.

Supplied Parts List

(1)Wall Plate-a (1)Right Monitor Bracket-c

(4)M4x12 Bolt-d (4)M5x12 Bolt-e (4)M6x12 Bolt-f (4)M8x16 Bolt-g

(4)M4x30 Bolt-h (4)M5x30 Bolt-i (4)M6x35 Bolt-j (4)M8x40 Bolt-k

(4)M4 Lock Washer-l (4)M5 Lock Washer-m (4)M6 Lock Washer-n (4)M8 Lock Washer-o

(1)Left Monitor Bracket-b

(4)M4/M5 Space-p (4)M6/M8 Space-q (8)M4/M5 Washer-r (4)M6/M8 Washer-s

(6)M8x90 Lag Bolt-t (6)Lag Bolt Washer-u

(6)M10x80 Concrete Anchor-v

Pls install the Plastic Knob on the Monitor Bracket(b,c) as left diagram before do the next step. Pls note the two knobs should be installed in the opposite way on the two monitor brackets.

+ 3 hidden pages