Monoprice 8100 User Manual

Pitching angle adjustment

4

• Tighten the screws til l the dis play angle can be fixed, then push or pull from top or bottom of scre en to adjust

the display to the desired angle.

• The pitching angle can be adjusted between -20° ~ +20 °, swivel: ±90°, pivot: ±10°, as shown in fig.4.1.

±9 0°

+2 0°

-20°

±9 0°

+1 0°-10°

INSTALLATION INSTRUCTIONS

M-J

Maintenance

Once you ha ve mounted the bracke t and the flat screen, ch eck that they are sufficiently se cure and safe to use.
You should check wh ethe r screws are fixe d well e ach two months. I f you ha ve any doubts reg ardi ng the
install ation, please consu lt our retailer or serv ice department for de tail.

fig. 4.1

Pitch in g angle :

-20° ~ +20°
Swive l: ±90°

20kg

(44lbs)

MAX

LCD Wall Mount

7

Max Load Cap aci ty: 2 0kg (44 lbs )

Model: MDA03-223

NOTE: Read enti re i ns truction shee t be fo re you start inst al la tion and assemb ly.

WARNING

• Do not begin the installation of the product before you have read and understood the
instructions and warnings contained in this installation sheet. If you have any question
regarding any of the instruction or warning, Please contact your local distributor.

• Please refer to installation guide recommendation for required distance from wall to
avoid risk of property damage.

• This product should only be installed by someone of good mechanical aptitude, with
experience and basic building, and fully understands.

• Make sure that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.

• Never exceed the maximum load capacity.

• If mounting to wood wall studs, make sure that mounting screws are anchored into
the center of the studs. Use of an “edge to edge” stud finder is highly recommended.

• Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.

Component Che ck li st

IMPORTAN T: Ensure you ha ve re cei ved a ll pa rts agains t the c omp one nt ch eck list pr ior t o ins tal lin g. If a ny parts

are m issin g or fa ult y, tel eph one t he sp eci al fr anchi ser f or a re pla cem ent .

Package M

M4x14

(x4) M5x14 ( x4)

M-A

ø ø10

D4 ( 4.5x )

washe r

M-E

(x4)

M-B

D (ø .5xø )

5 5 12

(x4)

washe r

M-F

M6x14 ( x4)

M-C

D6 (ø6. 3xø )

washe r

M-G

(x4)

16

M8x15 ( x4)

M-D

D8 (ø8. 3xø )

washe r

M-H

(x4)

16

• Tighten screws firmly, but do not over tighten. Over tightening can damage the items,
greatly reducing their holding power.

• This products intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury.

ø13.5 xø5.5 x3.2 (x 4)

M-I

3mm allen key (x1)

Package W

ST 5. 5x50 (x3)

lag bol t concr ete anc hor

W-A

Tools required

·

Phillips Head Screw driver(200mm length exclude the handle)

·

Electric drill and 8mm masonry bit for concrete wall installation

·

Marking Pen

·

Hammer

M-J

W-B

(x3)

21