Monoprice 8097 User Manual

INSTALLATION INSTRUCTIONS

Pitch in g angle :

-20° ~ +20° Swive l: ±90°

15kg

(33lbs)

MAX

LCD Wall Mount

Model: MDA03-113

Max Load Cap aci ty: 1 5kg (33 lbs )

NOTE: Read enti re i ns truction shee t be fo re you start inst al la tion and assemb ly.

WARNING

• Do not begin the installation of the product before you have read and understood the instructions and warnings contained in this installation sheet. If you have any question regarding any of the instruction or warning, Please contact your local distributor.

• Please refer to installation guide recommendation for required distance from wall to avoid risk of property damage.

• This product should only be installed by someone of good mechanical aptitude, with experience and basic building, and fully understands.

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.

Component Che ck li st

IMPORTAN T: Ensure you ha ve re cei ved a ll pa rts agains t the c omp one nt ch eck list pr ior t o ins tal lin g. If a ny parts

are m issin g or fa ult y, tel eph one t he sp eci al fr anchi ser f or a re pla cem ent .

Package M

• Never exceed the maximum load capacity.

• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an “edge to edge” stud finder is highly recommended.

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws firmly, but do not over tighten. Over tightening can damage the items, greatly reducing their holding power.

• This products intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

M4x14

(x4) M5x14 ( x4)

M-A

5 5 12

D (ø .5xø )

washe r

(x4)

M-D

M-B

3mm allen key (x1)

M-E

Package W

ST 5. 5x50 (x3)

lag bol t concr ete anc hor

W-A

Tools required

Phillips Head Screw driver(200mm length exclude the handle)

Electric drill and 8mm masonry bit for concrete wall installation

Marking Pen

Hammer

D4 ( 4.5x )

ø ø10

washe r

(x4)

M-C

(x3)

W-B

+ 2 hidden pages