Monoprice 8095 User Manual

INSTALLATION INSTRUCTIONS
Pitchin g an gle:
-20° ~ +20° Swivel: ±90°
15kg
(33lbs)
MAX
LCD Wall Mount
Max Loa d Cap aci ty : 15k g(3 3lbs)
NOTE: Read entire instruction sheet before you start installation and assembly.
WARNING
• Do not begin the installation of the product before you have read and understood the instructions and warnings contained in this installation sheet. If you have any question regarding any of the instruction or warning, Please contact your local distributor.
• Please refer to installation guide recommendation for required distance from wall to avoid risk of property damage.
• This product should only be installed by someone of good mechanical aptitude, with experience and basic building, and fully understands.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
Component Checklist
IMPORTANT: Ens ure y ou h ave r ece ived al l par ts agai nst t he comp one nt chec kli st prio r to in sta ll ing . If an y pa rts
are m is sin g or fa ul ty, te lep hon e the spe cia l franc his er for a re pla cemen t.
Package M
• Never exceed the maximum load capacity.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an “edge to edge” stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can damage the items, greatly reducing their holding power.
• This products intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
M4x14
(x4) M5x14 ( x4 )
M-A
5 5 12
D (ø .5xø )
washe r
(x4)
M-D
M-B
3mm allen key (x1)
M-E
Package W
ST 5. 5x 50 (x3)
lag bol t concr et e ancho r
W-A
Tools required
·
Phillips Head Screw driver(200mm length exclude the handle)
·
Electric drill and 8mm masonry bit for concrete wall installation
·
Marking Pen
·
Hammer
D4 ( 4.5x )
ø ø10
washe r
(x4)
M-C
(x3)
W-B
21
Loading...
+ 2 hidden pages