Monoprice 7846 User Manual

INSTALLATION GUIDE

Flat Panel Arm Mount

MDA-46

Support 32" to 46" Screens

Max Load Capacity: 125 lbs (57 kg)

VESA 400x400 compatible

WARNING

• Be sure to read this entire manual thoroughly and you fully understand all the instructions and warning before
attempting to begin your installation.

• This product should only be installed by someone who has a basic knowledge of buiding construction,installations and fully
understands these instructions.

• Make sure that the supporting surface will safely support the combined load of the mount, the display and all
attached hardware and components.

• This wall bracket will only supporting flat panel display

• If mounting to a wall of wood stud construction, be sure that mounting bolt are anchored to the center of the

studs.

• Always have someone assist you to lift and position your equipment.

• Tighten screws and bolts firmly, but do not over tighten. Over tightening can damage the items and greatly reduce

their ability to hold. Please refer to suggested torque values where applicable in these instructions.

Tools Needed for Assembly

• stud finder ("edge to edge" stud finder is recommended)

• phillips screwdriver

• pencil

• drill

• 3/16" drill bit for wood studs, 5/16" drill bit for concrete

• level

• tape measure

s(LCD,Plasma).The maximum load capacity is 125 pounds.

Table of Contents

Parts List .......................................................................................................................................................................... 3

Installation to Single Wood Stud Wall ................................................................................................................................... 4

Installation to Solid Concrete and Cinder Block .................................................................................................................... 5

Attaching the mount to Screens with VESA

Cable Management ............................................................................................................................................................. 8

®

Mounting Patterns

2 of 8

.................................................................................... 6,7

Before you begin, mak e sure all parts shown are included
with your product.

Parts may appear slightly different than illustrated.

Parts List

1

M6x16(x4)

philips pan head screw

￠12.7x6.0x￠12.7(x4)

spacer

F G H

2

M6x8(x8)

M6x30(x4)

philips pan head screw

B C D EA

M6x60(x3)

cross slotted head screw

￠6.2x1.5x￠13(x8)

M8x16(x4)

philips pan head screw

M6x40(x3)

concrete anchor

M8x35(x4)

philips pan head screw

AA

￠19x8.2x￠19.6(x4)

spacer

BB(X4)

3 of 8