Monoprice 7495, 7496 User Manual

Introduction

Thank you for purchasing these Monoprice Active Speakers!

User Manual

For best results, please read this manual completely before
attempting to install or use these speakers. Pay extra attention to
the Safety Tips and Warnings below to ensure both your own
personal safety and the long-term service from of these speakers.

Safety Tips and Warnings

Do not expose these speakers to water or moisture of any kind.
They are not waterproof and exposure could result in fire, electrical
shock, and damage to the speakers and surrounding property.

Take care to ensure that the power cords do not become worn or
damaged. Inspect the power cord for damage prior to plugging it
into a live electric circuit. If the cord is damaged replace it with a
standard PC power cord (IEC 60320 C13 plug to NEMA 5-15 plug).

When plugging or unplugging the power cord, grip the connector
head and not the cord itself. Pulling on the cord can result in
damage to the cord, which could in turn lead to an electric short
and/or fire.

2-Way Active Wall Mount Speakers

(Pair) - 25W

Never touch the power cord or speaker with wet hands or when
standing in water. Doing so could lead to electric shock.

Avoid installing or using the speakers in a humid or dusty environ­ment.

7495/7496

SPECIFICATIONSDIMENSION

196 m m

220 mm

INSTALLATION

Wall Wall

1 2

1. Ensure that the mounting surface can
support the speaker weight of Speaker weight
of 22.3 lbs (10.1 Kg).

220 mm

100 mm

AC 220 V~ 24 0V /50 Hz ~6 0H z

290 mm

23 5 m m

4mm

10m m

13.5m m
125 mm

2. Using the speaker bracket, mark the installation with a pencil. Use a
carpenter's level to ensure the bracket will be correctly aligned.
(Figure: Bracket dimensions)

MODEL

RMS

OUEPUT SENSITIVITY

FREQUENCY RESPONSE

AC POWE R SUPPLY

TREBLE CONTROL

BASS CONTROL

DIMENSION(mm)

GROSS WEIGHT

MPA-25-BK

25Wx2@8

0.7V

20Hz~20KHz/1W, 0.5db

AC120V/50Hz~60Hz

10db

10db

220X196X290

10.1Kg

AC120V/50Hz~60Hz

Power Supply

Power Switch

Wall Wall

3

3. You can mount the bracket using the
two keyholed mounting points or with a
single screw through the hole in the
center.

W all

4

4. Insert the speaker into the speaker
bracket and secure it in place using the
two bracket mounting screws.

W all

5

5. Your speaker is now mounted correctly.
Repeat the process with the other
bracket and speaker.

R/Speaker output
Power indicator
R/S indicator
L/S indicator

Right balanced input

Bass control

Treble control

Volume control

Mode switch

Left balanced input

3.5mm stereo jack input

L/R unbalanced input