
P/N 604212
APS 12 400W 12 inch
2 Way Active PA System with 3 Channel Mixer
P/N 604215
APS 15 400W 15 inch
2 Way Active PA System with 3 Channel Mixer
User's Manual

SAFETY WARNINGS AND GUIDELINES
Do not stack this speaker in such a way that it could fall on people or animals if it
was to become dislodged.
Do not subject the product to extreme force, shock, or fluctuations in temperature
or humidity.
Do not expose this device to water or moisture of any kind. Do not place drinks or
other containers with moisture on or near the device. If moisture does get in or on
the device, immediately unplug it from the power outlet and allow it to fully dry
before reapplying power.
Do not touch the device, the power cord, or any other connected cables with wet
hands.
If operating this speaker in a humid environment, ensure that no condensation
occurs. Condensation could cause damage to the speaker cone and could cause a
short in the amplifiers, which in turn could cause fire or severe electric shock.
Do not expose this device to excessively high temperatures. Do not place it in, on,
or near heat sources, such as a fireplace, stove, radiator, stage lights, smoke
machines, etc. Do not leave it in direct sunlight.
Do not place or install this device in an area where it can be exposed to excessive
amounts of dust, humidity, oil, smoke, or combustible vapors.
Unplug this device from the power source when not in use.
Take care to prevent damage to the power cord. Do not allow it to become
crimped, pinched, walked on, or become tangled with other cords. Ensure that the
power cord does not present a tripping hazard.
Never unplug the unit by pulling on the power cord. Always grasp the connector
head or adapter body.
Ensure that power is turned off and disconnected before making any electrical
connections.
Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or
detergents. For stubborn deposits, moisten the cloth with warm water.
This device has no user serviceable parts. Do not attempt to open, service, or
modify this device.
2

When installing this device, ensure that the mount is sufficiently robust to support
the weight of the unit and to prevent unwanted movement.
INTRODUCTION
The APS 12 and APS 15 active PA speakers are equipped with a ø35mm pole socket for
mounting on most standard speaker stands, such as the Monoprice 602350 PA Speaker
Stands with Air Cushion. They also have two M8x15mm suspension points for permanent
installations. Suspension of the speaker should ONLY be performed by a qualified
Structural Contractor or Engineer. Please follow all safety guidelines and codes for your
area. Monoprice is not responsible for failure and damages due to improper mounting
practices.
FEATURES
12" woofer with 2.5" voice coil and 50 oz. ferrite magnet (604212) or 15" woofer with
3" voice coil and 60 oz. ferrite magnet (604215)
1.35" (604212) or 1.75" (604215) titanium compression driver on 1" throat horn
3.8kHz (604212) or 4.2kHz (604215) crossover frequency
102dB (604212) or 106dB (604215) sensitivity
112dB (604212) or 114dB (604215) sound pressure level (SPL)
20Hz ~ 20kHz frequency response
Built-in 350 watt LF amplifier and 50 watt HF amplifier
90° horizontal and 60° vertical coverage
ø35mm pole mounting option
2x M8x15mm suspension point mounting option
3