Monoprice 6031 User Manual

Model：SVC-ST-100W

INSTRUCTION

1. Remove about 1/4” of insulation from the ends of all wires to be connected to the volume control and twist the exposed strands.

2. The removable connectors accept up to 14 gauge wire.

3. Loose the set screws on the Volume Control.

4. Connect the leads from AMPLIFIER to the set screws on the volume control labeled INPUT, with the LEFT L(+) and L(-) and RIGHT R(+) and R (-) wires. Inserted in the appropriately marked opening.Tighten the screws firmly.

5. Connect SPEAKER wires to the set screws on the volume control labeled OUTPUT, observing + (positive) and - (negative)polarity of left and right speaker.

6. Install the completed assembly in the junction

box. Insert carefully to avoid excessive strain on

the set screws. If necessary, pre-dress the wires

for easiest mounting.

Be careful not to allow speaker wire strands

to short out against case or other speaker

wire.

I N P U T

I N

Mounting depth:2.95”(75mm) from finished wall.

O U P U T

OUT