Monoprice 4563 User Manual

Monoprice Adjustable Tilt/Swivel Flat Panel Wall Mount
Model MLB-WA8S (PID# 4563)
VESA Compliant up to 700x500 Max Weight: 110lbs
Installati on Instructions
UNPACKING INSTRUCTIONS
Check the contents against the supplied parts list on the next page to assure that all components were received undamaged. Do not use any damaged or defective parts.
IMPORTANT SAFETY INFORMATION
Install and use this device with c are. Please read this entire m anual before atte mpting installat ion and carefull y follow all instructions contained herein. Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
Don’t understand the instructions in this manual or have any doubts about the safety of the installation.
You are uncertain about the nature of your wall.
Do not use this product f or any purpose or in any conf iguration not explicitly specif ied in these instructions. Mono price hereby disclaims any and all liability for injury or damage arising from incorrect assembly, incorrect mounting or any incorrect use of this product.
Note: The mounting components and hardware supplied in this pack age are not designed for installation to wall with steel studs or to cinder block walls. If the hardware you need for your installation is not included, please consult your local hardware store for proper mounting hardware for this application.
Supplied Parts List
drill a 2.5” deep hole at the desired height in each stud using a 3/16” drill bit.
Step 1 Mounting the Wall Plate to the Wall
Brick, Solid Concrete and Concrete Block Mounting:
Use the Wall Plate (part 1) as a template t o mark 7 hole locations on the wall. Three in the top row of slots, three more in the bottom row and the last between the top and bottom screws on the left hand side. Make sure these holes are level. Pre-Drill these hol es with a ½” masonry bit to at least 2.5” in depth. Insert a Concrete Anchor (part 8) into each of these holes. Make sure the anchor is seated completely flush with the concrete surface even if there is a layer of drywall or the other material in front. Attach the Wall Plate to the wall using 7 Lag Bolts (part 7), as shown in the diagram.
Wood Stud mounting:
The Wall Plate (part a) must be mounted to two wood studs. Use a stud finder to locate two adjacent studs. It is a good idea to verify where the studs are located with an awl or thin nail. Pre­Make sure these holes are in the center of the studs and level with each other. Use the Wall Plate as a template to mark the location of the other holes in each s tud. Drill pilot holes at each of the marked locations. Attach the Wall Plate to the wall using the 5 Lag Bolts (part 7).
Loading...
+ 2 hidden pages