Monoprice 18806 User Manual

Commercial Audio 60-Watt Powered Lectern

with Gooseneck Microphone and LED Light

TREBLE

MIC 1

0

0 10

-5 +5

MIC 2

BASS

0

0 10

-5 +5

MIC 3

AUX 1

0 10 0 10

PL

MIC 2

AUX 1 REC OUT

PRE-OUT

1 - GND
2 - HOT
3 - COLD

P/N 18806 Made in China

POWER

-60Hz
0

AC 120V 5

P/N 18806

User’s Manual

SAFETY WARNINGS AND GUIDELINES

Please read this entire manual before using this device, paying extra attention to these

safety warnings and guidelines. Please keep this manual in a safe place for future

reference.

 Do not install this device on an unstable surface where it could fall and cause

either personal injury or damage to the device and/or other equipment.

 Do not expose this device to excessive vibration.
 This device is intended for indoor use only.
 Do not touch the device, the power cord, or any other connected cables with

wet hands.

 If operating this speaker in a humid environment, ensure that no condensation

occurs. Condensation could cause damage to the speaker cones and could cause

a short in the amplifier, which in turn could cause fire or severe electric shock.

 Do not expose this device to excessively high temperatures. Do not place it in,

on, or near heat sources, such as a fireplace, stove, radiator, etc. Do not leave it

in direct sunlight.

 Prior to operation, check the unit and power cord for physical damage. Do not

use if physical damage has occurred.

 Before plugging the unit into a power outlet, ensure that the outlet provides the

same type and level of power required by the device.

 This device uses a grounded power cord and requires a ground connection for

safe operation. Ensure that the power source has a proper ground connection.

Do not modify the plug or use a "cheater" plug to bypass the ground connection.

 Unplug this device from the power source when not in use.
 Take care to prevent damage to the power cord. Do not allow it to become

crimped, pinched, walked on, or become tangled with other cords. Ensure that

the power cord does not present a tripping hazard.

 Never unplug the unit by pulling on the power cord. Always grasp the connector

head or adapter body.

 Ensure that power is turned off and disconnected before making any electrical

connections.

2

 Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or

detergents. For stubborn deposits, moisten the cloth with warm water.

 This device has no user serviceable parts. Do not attempt to open, service, or

modify this device.

INTRODUCTION

Thank you for purchasing this Powered Lectern! This lectern features a built-in 60-watt

amplifier and speakers, so it can serve as a stand-alone audio system for presentations.

It includes a gooseneck microphone and LED lamp, which attach to the top. A balanced

pre-amp output allows you to connect it to an external audio system to replace or

augment the lectern's built-in sound system. An additional 3-pin Male 91 MC3M

connector with phantom power inside the apron allows you to connect an additional

condenser microphone, while a 1/4" jack on the lectern column allows you to connect

an additional dynamic microphone. Line level RCA inputs allow you to add an external

audio source to provide music or other audio material, while line-level RCA outputs

allow you to record your presentation.

FEATURES

 Includes gooseneck dynamic microphone and gooseneck LED lamp
 Built-in 60-watt amplifier and speakers
 Balanced pre-amp output
 Line level RCA input
 Balanced 1/4" dynamic microphone input
 Line level RCA outputs for recording presentations

3