FEATURES .............................................................................................................................................................................................................. 4
CUSTOMER SERVICE .................................................................................................................................................................................... 5
Front Panel ..................................................................................................................................................................................................... 6
SHORT CIRCUIT PROTECTION .............................................................................................................................................................. 7
Single Rack-Mount Setup ................................................................................................................................................................. 8
TECHNICAL SUPPORT ............................................................................................................................................................................... 14
Notice for FCC .......................................................................................................................................................................................... 15
Notice for Industry Canada ........................................................................................................................................................... 15
2
SAFETY WARNINGS AND GUIDELINES
Please read this entire manual before using this device, paying extra attention to these
safety warnings and guidelines. Please keep this manual in a safe place for future reference.
This device is intended for indoor use only.
Do not expose this device to water or moisture of any kind. Do not place drinks or
other containers with moisture on or near the device. If moisture does get in or on
the device, immediately unplug it from the power outlet and allow it to fully dry
before reapplying power.
Do not touch the device, the power cord, or any other connected cables with wet
hands.
This device uses a grounded power cord and requires a ground connection for safe
operation. Ensure that the power source has a proper ground connection. Do not
modify the plug or use a "cheater" plug to bypass the ground connection.
Do not expose this device to excessively high temperatures. Do not place it in, on,
or near heat sources, such as a fireplace, stove, radiator, etc. Do not leave it in direct
sunlight.
This device ventilates excessive heat through the slots and openings in the case. Do
not block or cover these openings. Ensure that the device is in an open area where
it can get sufficient airflow to keep from overheating.
Prior to operation, check the unit and power cord for physical damage. Do not use if
physical damage has occurred.
Take care to prevent damage to the power cord. Do not allow it to become
crimped, pinched, walked on, or become tangled with other cords. Ensure that the
power cord does not present a tripping hazard.
Never unplug the unit by pulling on the power cord. Always grasp the connector
head or adapter body.
Ensure that power is turned off and disconnected before making any electrical
connections.
3
Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or
detergents. For stubborn deposits, moisten the cloth with warm water.
This device has no user serviceable parts. Do not attempt to open, service, or
modify this device.
INTRODUCTION
Thank you for purchasing this Unity 100-Watt Bridgeable Power Amp! This 2-channel class
D power amplifier features a stereo speaker output, with support for 4-ohm and 8-ohm
speakers. It can deliver 50 watts per channel into 8-ohm loads or 65 watts per channel into
4-ohm loads. Additionally, the output can be bridged to provide 120 watts to a single 8-
ohm speaker. It includes a buffered loop line output of the original signal for driving
another power amplifier in distributed whole house audio systems. The amp can be
configured for always on, signal detection, or triggered power on status. It also includes a
12-volt trigger output for controlling other devices.
FEATURES
Class-D amplifier providing 50 watts/channel (RMS) into 8 ohm loads or 65
watts/channel into 4-ohm loads
Bridgeable output provides 120 watts into a single 8-ohm load
4-pole detachable speaker screw connector (Phoenix connector) with support for
up to 12 AWG speaker wire
12-volt trigger input for power-on/off
12-volt trigger output for controlling other devices
Buffered loop output of original signal for connecting additional amplifiers
Rear panel volume gain adjustment
Built-in thermal and short circuit protection circuits
Includes rack-mount ears
4
CUSTOMER SERVICE
The Monoprice Customer Service department is dedicated to ensuring that your ordering,
purchasing, and delivery experience is second to none. If you have any problem with your
order, please give us an opportunity to make it right. You can contact a Monoprice
Customer Service representative through the Live Chat link on our website
www.monoprice.com during normal business hours (Mon-Fri: 5am-7pm PT, Sat-Sun: 9am-
6pm PT) or via email at support@monoprice.com
PACKAGE CONTENTS
Please take an inventory of the package contents to ensure you have all the items listed
below. If anything is missing or damaged, please contact Monoprice Customer Service for a
replacement.
1x 100-watt stereo power amplifier
1x AC power cord (NEMA 5-15 to IEC 60320 C13)
1x Power cord anchor
2x Short rack-mount ears
1x Long rack-mount ear
1x Bridge plate
6x Button head screws
4x Countersunk screws
4x Rubber feet
1x User's manual
5
Loading...
+ 10 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.