Monoprice 10222 User Manual
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs
MONOPRICE
Self Amplified Digital Keypad
with Bluetooth and Analog Inputs
PID 10222
1
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs
INTRODUCTION
This Self-Amplified Digital Keypad features a 6 watts/channel amplifier, a Bluetooth
audio receiver, and three analog audio inputs. It provides an easy to connect central
location for playing back audio material from a variety of portable sources. IR repeater
functionality allows a remote source device to be controlled using its standard IR remote
control.
PACKAGE CONTENTS
After receiving the product, please inventory the contents to ensure you have all the
proper parts, as listed below. If anything is missing or damaged, please contact
Monoprice Customer Service for a replacement.
1x Self Amplified Digital Keypad
1x Front plate
1x User's manual
FEATURES
Includes two analog audio inputs on the front panel
Includes one internal, hard wired analog audio input
Features a Bluetooth receiver with A2DP support
Includes IR repeater capability (IR transmitter bulb not included)
SPECIFICATIONS
Amplifier Power: 6 watts/channel RMS into 8 ohms, 12 watts/channel RMS into 4
ohms
Stereo Audio Inputs: hard wired, 3.5mm TRS, 2x RCA, and Bluetooth
Frequency Response: 35Hz ~ 20KHz
Input Sensitivity: 200mV (Lo) / 1.0V (Hi)
Volume Control Range: -75dB
Bass Control Range: +/- 12dB
Treble Control Range: +/- 12dB
Balance Control Range: +/- 30dB
IR Frequency: 38KHz
Input Power: 24VDC
Bluetooth Version: 2.1+EDR with A2DP profile
Bluetooth Reception Range: up to 30 feet
Supported Speaker Wire: 14-22 AWG
Dimensions: 5.5" x 4.7" x 1.8"
Weight: 8.8 oz
2
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs
SAFETY WARNINGS
1. This device is intended for indoor use only. Do not expose this device to water or
moisture of any kind.
2. Ensure that the wire connections are clean, with no stray wire strands anywhere.
3. Double check all connections before applying power.
4. Do not provide a speaker load lower than 4 ohms to the amplifier. Doing so can
cause damage to the amplifier and could result in a fire.
5. Do not install or operate in close proximity to a heat source, such as a furnace,
radiator, or fireplace.
CONNECTION NOTES
The Bluetooth Audio receiver and the 2x RCA stereo analog jacks are in parallel. If an
audio source is applied to both inputs they will be mixed with higher volume levels.
The 3.5mm TRS jack and the internal hard wired terminals are also in parallel. If an
audio source is applied to both inputs they will be mixed with higher volume levels.
The 3.5mm jack/hardwired terminals have priority over the Bluetooth/RCA inputs. If an
audio source is present on both the 3.5mm/hardwired input and the Bluetooth/RCA
input, only the source(s) from the 3.5mm/hardwired input will be heard.
Note that combining audio sources in this way is not recommended and could cause
damage to your equipment. The only proper way to mix audio signals is using an audio
mixer. Therefore we highly recommend against applying an audio signal to both the
3.5mm and hardwired inputs. Similarly, we recommend to not use both the Bluetooth
receiver and RCA jacks at the same time.
3
Loading...