Monogram ZXD30P Installation

REMOVE ORIGINAL
DRAWER FRONT

• Remove the three screws from the bottom
of the drawer edge.

• Remove the four screws on the inside
of the drawer at the top. Retain all screws.

– Support the drawer front as you remove screws

to prevent the front panel from falling

.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• IMPORTANT – Save these instructions

for local inspector’s use. Observe all governing
codes and ordinances.

• Note to Installer – Be sure to leave these
instructions with the Consumer.

• Note to Consumer – Keep these instructions
for future reference.

Installation
Instructions

PROFESSIONAL STYLE PANEL

ACCESSORY KIT

ZXD30P

PARTS SUPPLIED

Stainless Steel Professional Style Drawer
Accessory

This kit contains a stainless steel professional style panel
with a handle and a lamp jewel imbedded in the bottom
right side. Install the warming drawer according to the
installation instructions packed with the product.

NOTE: The ZXD30P professional drawer panel with
handle is a one-piece assembly that replaces the
original drawer front and tubular handle. The original
tubular handle (or a custom handle) cannot be
installed onto this professional drawer panel.
This ZXD30P accessory is designed to fit 30" warming
drawers manufactured after February 2006.

PREPARE DRAWER
FOR PANEL INSTALLATION

IMPORTANT: The drawer must be installed into

the cabinet before opening the drawer.

• Open the drawer approximately halfway.

• Turn the warming drawer to “OFF.”

INSTALL PANEL ONTO DRAWER

• Install the panel assembly to the exposed drawer
front using the original 7 screws.

REMO VE THE PACKAGING

• Open the carton and remove the panel.
Remove all protective covering on both sides.

CAUTION:

Keep all plastic material
away from babies and small children. Plastic could
pose a choking or suffocation hazard.

STEP 2

STEP 3

STEP 4

STEP 1

31-10701-1

10-08 JR

Printed in the United States

TOOL AND MATERIALS REQUIRED

• Phillips screwdriver