Monogram ZUG30 Installation Manual
Installation Instructions – ZUG30 Heater Kit/Cover
sult in death or serious injury.
TO BE USED WITH HOUSEHOLD REFRIGERATORS
30" BUILT-IN
BOTTOM-FREEZER, 2 DRAWER
Unit 1 - Spacer Clips Installed
Unit 2 - Heater Installed
ALL REFERENCES TO ASSEMBLY ARE FROM THE FRONT OF THE UNITS
PARTS PROVIDED:
Installation Instructions (1)
Heater (1)
Transformer (1)
Plastic Cover (1)
Brackets (2)
Tools Required:
#2 Phillips Head Screw Driver
Step Ladder
Open Wrench Set
5 mm. Allen Wrench
NOTE: WHILE PERFORMING INSTALLATIONS
DESCRIBED IN THIS BOOK, SAFETY GLASSES OR
GOGGLES SHOULD BE WORN.
Spacer Clips (8)
Strain Relief (1)
Screw, 4.8 x 13 (4)
Bolt, M4 x 18 (2)
Nut, M4 (2)
PPE Required:
Safety Glasses
Safety Gloves
STOP
Disconnect power to the appliance before beginning installation.
Do not operate the refrigerator until the installation is complete.
Unit 1
Washer, star (4)
Bolt, M6 x 45 (3)
Nut, M6 (3)
Washer, at (6)
Wiring 'Y' Splitter (1)
Unit 2
BEFORE YOU BEGIN
Read these instructions
completely and carefully.
WARNING
WARNING
This refrigerator is top heavy and must be handled with care.
Failure to do so can result in the unit tipping over and re
Do not cut lower banding on units.
Do not remove foam base pad from front of units.
IMPORTANT SAFETY NOTICE:
This kit is to be installed by a qualied service technician only. Any attempt to repair a major appliance may result in
personal injury and property damage. Neither the manufacturer nor the seller can be responsible for the interpretation
of this information or assume any liability in connection with its use.
197D9290P001 31-45446-1 05-12 GE
1. This heater kit will only t two units, if the doors face each other when opened. Door swing of unit 1 must
Unit 1
Unit 2
be switched from right hand swing to left hand swing. Refer to Installation Instructions 31-46542 for proper
procedure and safety measures.
Required Door Swing
(view from above)
Unit 1 Unit 2
2. On sides of refrigerators, remove white stickers from top and center location, to reveal holes in the case. Remove
any labels from sides of refrigerators and clean the surfaces.
3. Attach spacer clips to the inner side wall of Unit 1. Line up holes in Spacer Clips 1 and 4 with holes in case. Attach
clips 2 and 3 evenly spaced between 1 and 4. Note that clips 2 and 3 are dierent that the six other clips. It is very
important that you use clips 2 and 3 in those locations only. Clip 6 attaches on the bottom front corner, along the
front edge of Unit 1, same as clips 1 and 4. Clip 5 spaced evenly between clip 4 and 6. Clip 7 attaches to the top,
rear corner of Unit 1. Orientation is not critical. Clip 8 is attached in a later step.
Unit 1
Spacer Clips 2,3
Spacer Clips
Unit 2
7
1
2
3
4
5
8
6
1
2
3
4
5
6
1,4-8
7
8
2
Loading...