MONOGRAM ADVANTIUM® 120 ABOVETHE-COOKTOP SPEEDCOOKING OVEN
ZSA1202PSS
THE MONOGRAM STATEMENT COLLECTION
Edge-to-edge handles, polished sta inless steel, and ha nd-finished
edges convey a sense of solidity a nd beauty
SPEEDCOOK TECHNOLOGY
Uses halogen light to cook foods to delicious perfection—
two to four times faster than a conventional oven—no
preheating required
5-IN-1 OVEN WITH ADVANTIUM® TECHNOLOGY
Experience exceptional flexibility and cooking results with the
innovative five-in-one oven. Adva ntium® technology enhanced, it
can be used as a convection oven, toaster oven, warming/proofing
oven, precision cook oven and microwave
EASY-TO-USE-CONTROLS
Make it easy to select from more than 175 preprogra mmed recipes
SPACIOUS INTERIOR
13.6" turntable and two full-width oven racks easily accommodates
a roast or three 8-1/2" x 11" casserole dishes
FOUR-SPEED, 300-CFM VENTING SYSTEM
Efficiently clears away smoke a nd steam from
the cooktop
CONVENIENT TASK LIGHTING
Provides three levels of illumination to
suit your needs
FLEXIBLE ABOVE-THE-COOKTOP
CONFIGURATION
Makes the most of your kitchen space
For questions about your
appliance, please call 1-800-626-2000.
PAGE 1 OF 3
Product Specication Revised 10/20
Above-the-cooktop Advantium oven
Dimensions (in inches)
0V outlets
INSTALLATION INFORMATION:
is information is not intended to be used for installing unit
described. Before installing, consult installation instructions packed
with product/kit for current dimensional data.
66" MIN.
Mounting
height
from floor
25-1/2
100˚
Door open
(without
obstruction)
30 max
Minimum distance from
door hinge side to adjacent
wall should equal 1/2-inch.
Note: Outside venting is optional. Vent (duct) can be horizontal or vertical.
width required
13"
MAX.
12"
MIN.
16 max
16 max
30" MIN.
16-3/8 max
(Rear)
Exhaust outlet
connects to
3-1/4" X 10" duct
Cabinet Front
Cabinet Bottom Shelf
Self-Aligning Screw
Oven Top
240V and 12
need to be spaced on
the side if the desire is
to setup with top
exhaust.
A
A
SIDE VIEW A-A
Filler Block
Equivalent
to Depth of
Cabinet Recess
This distance can
NOT exceed 2” to
ensure proper
installation with
the provided
screws.
IMPORTANT:
Please read carefully. For personal
safety, is Applia nce Must be properly grounded
to avoid severe or fatal shock.
Do not, under any
circumstances, cut, deform, or remove
any of the prongs from the power cord.
Insure proper
ground exists
before use.
Dimensions in parentheses a re in centimeters unless otherwise noted.
Actual product dimensions may vary due to ma nufacturing tolerances.
For questions about your
appliance, please call 1-800-626-2000.
Do not use with an extension cord.
NEMA 14-30R WALL RECEPTACLE
Product Specication Revised 10/20PAGE 2 OF 3
OPTIONAL ACCESSORIES
Grille
FILTER KIT
JX81D–RECIRCULATING CHARCOAL
FILTER KIT
To be used when the Advantium oven
cannot be vented to the outside.
HELPFUL TIPS
HOOD EXHAUST DUCT
Outside ventilation requires a
hood exhaust duct. Read the
following carefully.
EXHAUST CONNECTION:
e hood exhaust has been designed
to mate with a standard 3-1/4" x 10”
rectangula r duct.
If a round duct is required, a
rectangula r-to-round transition
adaptor must be used. Do not
use less than a 6" diameter duct.
REAR EXHAUST:
If a rea r or horizontal exhaust is to
be used, care should be taken to align
exhaust with the space between studs,
or wall should be prepared a t the time
it is constructed by leaving enough
space between the wall studs to
accommodate exha ust.
MAXIMUM DUCT LENGTH:
For satisfactory a ir movement, the
total duct length of 3-1/4" x 10"
rectangula r or 6" diameter round duct
should not exceed 140 equivalent feet.
Duct EQUIVALENT
Rectangular-To-Round
Transition Adaptor
Wall Cap 40 Ft.
90° Round Elbow 10 Ft.
45° Round Elbow 5 Ft.
90° Rectangular Elbow 25 Ft.
45° Rectangular Elbow 5 Ft.
Roof Cap 24 Ft.
5 Ft.
FILLER PANEL KITS JX36B
When replacing a 36" ra nge hood, this kit
fills in the additional width to provide a
custom built-in appeara nce. For installation
between cabinets only; not for end-ofcabinet installa tion. Each kit contains two
3"-wide filler panels.
ELBOWS, TRANSITIONS,
WALL AND ROOF CAPS, etc.,
present additional resistance to a irflow
and a re equivalent to a section of
straight duct which is longer tha n their
actual physical size. When calculating
the total duct length, add the equivalent
length of all transitions a nd adaptors
plus the length of all straight duct
sections. e chart below shows the
approximate feet of equivalent
length of some typical ducts.
For questions about your
appliance, please call 1-800-626-2000.
PAGE 3 OF 3
Product Specication Revised 10/20
Loading...