Installation
Instructions
ZPRO0700S
Professional Style
Stainless Steel Door Panel Kit
For ZBD6890 and ZBD0700
Lay the dishwasher on its back.
Install the heavy duty door springs. The dishwasher is
shipped from the factory with a temporary set of balance
springs. The heavy duty springs provided must be used
to balance the installed stainless steel panel on the
dishwasher.
• With the dishwasher on the wooden skid, close and
latch the door.
• Remove and discard both factory installed door springs.
• Attach the new heavy duty door springs. Engage the end
with the short hook into the support leg and the long
hook into the cable.
Stand the dishwasher upright.
Secure the panel to the door by inserting the top and
bottom shoulder washers into the matching keyhole slots.
Make sure all 4 washers engage the keyhole slots.
Press the panel against the door and push downward
until the washers are fully engaged into the keyhole slots.
The panel should align evenly with the top and sides.
Open dishwasher
door and drive
the supplied
#6 x 2” Phillips
screws through
the inner door
and into the
panel. Drive
one screw at
the top and then
one screw on each
side as shown.
Pub. No. 31-30575-1
Part No. 206C1559P115
09-04 JR
Printed in the United States
Decrease
Tension
Increase
Tension
Correct Spring
Cable Routing
Shoulder
Pulley
Use This
Mounting
Hole
Recommended Position of
Spring Hook to Cable Shown
Long Hook
End of Spring
Open and close the door.
• If the door drops open when released, increase spring
tension. If the door closes when released, decrease
tension. See the recommended
cable attachment position
shown below.
TIP: If the door does not open easily or falls too quickly,
check spring cable routing. The cable is held in place by
“shoulders” on the pulley. Check to be sure the cable has
not slipped over the pulley shoulders.
IMPORTANT: Adjust both balance springs to the same
amount of tension to prevent excessive door twisting
during use.
Stainless
Steel Panel
Dishwasher
Door
Shoulder Washers
Engage Keyhole Slots
Stainless
Steel Panel