Monogram ZK1SN189NLH Installation Manual

Installation

Stainless Steel

Door Panel Kit

Instructions

Before you begin - Read these instructions completely
and carefully.

Note to Installer: Be sure to leave these instructions with

the Consumer.

WARNING

These appliances are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the appliance with the anti-tip system before
installing door panel kit.

This kit provides for the installation of the Stainless Steel Door Panel Assemblies

Tip Over Hazard.

ZK1SN189NLH LH 18” STAINLESS STEEL DOOR PANEL
ZK1SN184NRH RH 18” STAINLESS STEEL DOOR PANEL
ZK1SN249NLH LH 24” STAINLESS STEEL DOOR PANEL
ZK1SN244NRH RH 24” STAINLESS STEEL DOOR PANEL
ZK1SN309NLH LH 30” STAINLESS STEEL DOOR PANEL
ZK1SN304NRH RH 30” STAINLESS STEEL DOOR PANEL
ZKSP1H1CNSS MINIMALIST HANDLE FOR STAINLESS STEEL PANELS ONLY
ZKSP1H1PNSS STATEMENT HANDLE FOR STAINLESS STEEL PANELS ONLY

Note to Consumer: Keep these instructions with your
Installation Instructions for future reference.

WARNING

Hazard

Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.

Door Trim Pinch Point

Tools and Materials Required:

T20 and T30 Torx driver / bits
Instructions for this kit are also included in the full installation instructions included with the unit.

31-1000410 Rev. 1 11-19 GEA

Installation Instructions

INSTALL STAINLESS PANEL

Ŷ Remove bottom hinge cover and retain the 4 T30 Torx

screws for later installation.

T30 Torx
screws

Bottom
hinge
cover

Ŷ Open door to 90°. Slide the panel onto the door with

the panel brackets interlocking on top and bottom with
the door brackets (make sure not to slide the panel into
the cabinetry surround). Center the panel on the door,
then slowly close the door while watching to make sure
the panel does not contact the surrounding cabinetry.

Panel
Bracket

Door
Bracket

Panel

Ŷ With the door fully closed, carefully slide the panel

towards the cabinetry with the goal gap of 1/8”.

Overlay
Panel

Cabintery
Surround

1/8” gap

FOLLOW THE REMAINDER OF THE STAINLESS DOOR

PANEL INSTALLATION INSTRUCTIONS IN THE UNIT

INSTALLATION INSTRUCTIONS TO ADJUST AND

SECURE THE DOOR PANEL.