Monogram ZIS360N, ZISB360D, ZISW360D, ZISS360N, ZISS360D Installation And Design Manual
...
Installation
Instructions
If you have questions, call 800.626.2000 or visit our website at: www.monogram.com
Side by Side Refrigerators
ZIS360N, ZISB360D, ZISW360D
ZISS360N, ZISS360D
ZIS420N, ZISB420D, ZISW420D
ZISS420N, ZISS420D
ZIS480N, ZISB480D, ZISW480D
ZISS480N, ZISS480D
Design Guide
With Installation Instructions
Monogram.
®
We bring good things to life.
Safety Information
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT - Save these instructions for
local inspector’s use. Observe all governing
codes and ordinances.
• Note to Installer - Be sure to leave these instructions with the Consumer.
• Note to Consumer - Keep these instructions with
your Owner’s Manual for future reference.
WARNING:
This appliance must be properly grounded. See
“Grounding the Refrigerator,” page 10.
AVERTISSEMENT
Cet appareil doit être correctement mis à la terre.
Consulter «␣ Mise à la terre du réfrigérateur␣ », page 10.
If you received a damaged refrigerator, you should
immediately contact your dealer or builder.
CAUTION:
Due to the weight and size of this refrigerator, and to
reduce the risk of personal injury or damage to the
product - TWO PEOPLE ARE REQUIRED FOR
PROPER INSTALLATION.
PRUDENCE
À cause du poids et de la taille de ce réfrigérateur et
pour réduire le risque de blessure et de dommages, IL
FAUT DEUX PERSONNES POUR FAIRE
L’INSTALLATION CORRECTEMENT.
Skill Level - Installation of this refrigerator requires
basic mechanical, carpentry and plumbing skills.
Proper installation is the responsibility of the installer. Product failure due to improper installation is
not covered under the GE Appliance Warranty. See
the Owner’s Manual for warranty information.
WARNING:
• These refrigerators are top-heavy and must be
secured to prevent the possibility of tipping forward. Anti-Tip protection is required. See page 12
for details.
• Use this appliance only for its intended purpose.
• Immediately repair or replace electric service cords
that become frayed or damaged.
• Unplug the refrigerator before cleaning or making
repairs.
• Repairs should be made by a qualified service
technician.
AVERTISSEMENT
• Ces réfrigérateurs sont lourds en haut et il faut les
arrimer pour éviter leur basculement. Il faut avoir
un système de protection contre le renversement.
Voir les détails page 12.
• Il ne faut utiliser cet appareil que pour l’utilisation
appropriée.
• Réparer ou remplacer immédiatement tout cordon
électrique effiloché ou endommagé.
• Il faut débrancher le réfrigérateur avant le
nettoyage ou toute intervention.
• Les réparations doivent être faites par un
technicien qualifié.
For Monogram local service in your area,
1-800-444-1845.
For Monogram service in Canada
1-888-880-3030
For Monogram Parts and Accessories, call
1-800-626-2002.
www. monogram.com
CONTENTS
Planning Guide
The Installation Space ....................................3
Dimensions and Clearances ..........................3
130° Door Swing .............................................. 4
90° Door Swing ................................................ 5
Customization Basics ..................................... 6
1/4" Framed Panel Dimensions ......................7
3/4" Overlay Panel Dimensions ...................... 8
Raised Overlay Panel Design ........................ 9
Side Panels .....................................................10
Installation Instructions
Tools, Hardware, Materials ......................... 10
Grounding the Refrigerator ..........................10
Step 1, Remove Packaging .......................... 11
Step 2, Install Water Line .............................11
Step 2A, RO Water Line ................................12
Step 3, Install Side Panels ........................... 12
Step 4, Install Anti-Tip Brackets ................. 12
Step 5, Level Refrigerator ............................ 13
Step 6, Secure Refrigerator to Cabinetry .. 13
2
Step 7, Adjust Door Swing ........................... 13
Step 8, Install Grille Panel ............................14
Step 9, Install Framed Panels ......................15
Step 9A, Install Overlay Panels ...................16
Step 10, Install Dispenser Trim ....................17
Step 11, Connect Water Supply .................. 17
Step 12, Connect Power ...............................18
Step 13, Start Icemaker ................................ 18
Step 14, Install Toekick ................................. 18
B
A
Design Guide
THE INSTALLATION SPACE
36" Models 12"
42" Models 18"
48" Models 20"
*Finished Width
7"
84 1/2" max
83 1/2" min
Finished
Opening
*The finished cutout width must be:
35-1/2" for 36" models
41-1/2" for 42" models
47-1/2" for 48" models
Electrical
Area
24"
5"
Water Supply
3 1/2"
5"
74" From Floor
to Bottom
of Electrical
5"
3 1/2"
DIMENSIONS AND CLEARANCES
35", 41", or 47"
Case Width
*84"
36", 42", or 48"
Frame to Frame
Product Clearances
These refrigerators are equipped with a 2 position
door stop. The factory set 130° door swing can be
adjusted to 90° if clearance to adjacent cabinets or
walls is restricted.
130° Door Swing
* Shipping height.
The height may
be adjusted from
83-1/2" to 84-1/2"
by adjusting leveling
legs and wheels.
90° Door Swing
Water And Electrical Locations
The opening must be prepared with the electrical and
water supply located as shown.
The cutout depth must be 24".
23-7/8"
Behind
Frame
C
Designed for industry standard flush installation. The
refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
Note: GFI (ground fault interrupter) is not
recommended.
• Water line can enter the opening through the floor
or back wall. The water line should be 1/4" O.D.
copper tubing between the cold water line and
water connection location, long enough to extend
to the front of the refrigerator. Installation of an
Allow minimum clearances for freezer door (Dimension A) and fresh food door (Dimension B) for a full
130° door swing and to allow for pan removal.
4" minimum clearance is required when door swing
is adjusted to 90°. If the 90° door stop position is
used, pan access is maintained, but pan removal is
restricted.
See illustrations pages 4 and 5 to determine door
swing interaction with adjacent cabinets or
countertops.
Models A B C
36" 13" 15" 20-5/8"
42" 13" 19" 26-5/8"
48" 15" 20" 28-5/8"
easily accessible shut off valve in the water line is
recommended.
3
Design Guide
Refrigerator
23-7/8" From
Rear of
Refrigerator
Case
Trim
1/4"
1/2"
3/4"
1"
1-1/4"
1-1/2"
1-3/4"
2"
3"
2-3/4"
2-1/2"
2-1/4"
1/4"
1/2"
3/4"
1"
3/4" Overlay
Panel
(Nominal Size)
Top View
130° DOOR SWING
(factory setting)
Scale 1:1
IMPORTANT NOTE –
FOR DISPENSER MODELS:
Dispenser models are supplied with two
dispenser trims, one to fit framed panels and
one for overlay panels. Dispenser trim fit to
the custom panel depends on correct panel
thickness. Framed panels must be 1/4"
nominal. Overlay panels should be constructed
as shown to accomplish a total 1.100" thickness.
See pages 7 and 8 for details.
Door
1/4"
1/2"
3/4"
1"
1-1/4"
4
Design Guide
Refrigerator
Case Trim
23-7/8"
From Rear of
Refrigerator
1/4"
Top View
90° DOOR SWING
(optional setting)
Scale 1:1
IMPORTANT NOTE –
FOR DISPENSER MODELS:
Dispenser models are supplied with
two dispenser trims, one to fit framed
panels and one for overlay panels.
Dispenser trim fit to the custom
panel depends on correct panel
thickness. Framed panels must be
1/4" nominal. Overlay panels should
be constructed as shown to accomplish a total 1.100" thickness. See
pages 7 and 8 for details.
Door
1/4"
1/2"
3/4"
1"
1-1/4"
1-1/2"
3/4" Overlay
Panel
(Nominal Size)
1/2"
3/4"
1"
1-1/4"
5
Standard Door Handles
3/4" Overlay Panel
.10" Thick Spacer Panel
1/4" Thick Backer Panel
Design Guide
CUSTOMIZATION BASICS:
Framed Or Overlay Panels, Custom Handles and Accessory Kits
Stainless Steel Wrapped Models
36" wide models - ZISS360N, ZISS360D
42" wide models - ZISS420N, ZISS420D
48" wide models - ZISS480N, ZISS480D
Trimmed Models
36" wide models - ZIS360N, ZISB360D, ZISW360D
42" wide models - ZIS420N, ZISB420D, ZISW420D
48" wide models - ZIS480N, ZISB480D, ZISW480D
Stainless Steel Wrapped Refrigerators
Stainless Steel wrapped refrigerators have wrapped
doors and grille panel, beveled edges, and tubular
stainless steel handles that coordinate with other
Monogram appliances. These models are shipped
ready for installation.
Trimmed Refrigerators
Trimmed refrigerators are designed to be customized
with decorative panels. Field installed custom door and
grille panels are required.
Framed panels
You may install 1/4" thick custom panels from your
cabinet manufacturer. The decorative panel slides into
the factory installed trim. Or, order black, white and
stainless steel accessory panels from your Monogram
dealer.
Overlay panels
You may also choose to install custom overlay panels
from your cabinet manufacturer. This design provides a
seamless appearance which integrates smoothly with
surrounding cabinetry.
Standard supplied handles shown in 3/4" overlay panel position.
Door Handles
The standard supplied handles can be adjusted to
accommodate both framed or overlay panels. Custom
handles of your choice, supplied by your cabinet maker
can also be installed. If desired, you may order ZKHSS2
Monogram stainless steel tubular handle kit.
Side Panels
Side panels must be used whenever the sides of the
refrigerator will be exposed.
Framed Panel
Standard supplied handles shown in 1/4" panel position.
Standard Door Handles
Optional Accessory Kits
ZKHSS2: Monogram Tubular Stainless Steel handles
designed to fit framed or overlay panels.
Accessory Panels
White, black and stainless steel accessory panels are
available from your Monogram dealer. Panels are cut to
size and ready to install.
Models White Black Stainless
Acrylic Acrylic Steel
ZISW480D ZPW480D ZPS480D
ZISB480D ZPB480D ZPS480D
ZIS480N ZPW480N ZPB480N ZPS480N
ZISW420D ZPW420D ZPS420D
ZISB420D ZPB420D ZPS420D
ZIS420N ZPW420D ZPB420N ZPS420N
ZISW360D ZPW360D ZPS360D
ZISB360D ZPB360D ZPS360D
ZIS360N ZPW360N ZPB360N ZPS360N
6
Loading...