Monogram ZGU366NPSS Specifications
MONOGRAM 36" PROFESSIONAL GAS RANGETOP
WITH 6 BURNERS (NATURAL GAS)
DIMENSIONS AND INSTALLATION INFORMATION
(IN INCHES)
Professional rangetops oer a number of choices in size
and rangetop configurations.
PRODUCT DIMENSIONS AND CLEARANCE
A 36"- or 42"-wide professional vent hood with a minimum
480 CFM is recommended for installation over this rangetop.
Clearances between rangetop and side wall or combustible
material must be at least 12" on each side.
ZGU366NPSS
* The opening between a 4" high backsplash must be 36"
to allow the rangetop to slide back against the wall.
WARNING
Installations without a hood require 48" minimum to
combustibles above the rangetop. A custom hood
installation with exposed horizontal combustible
surfaces must have an "auto-on" feature. Refer to hood
installation instructions for specific hood clearances. The
surface of the entire back wall above the countertop
and below the hood must be covered with a noncombustible material such as metal, ceramic tile, brick,
marble or other stone.
Allow 8" free space below the top surface of
countertop. Allow additional clearances below the
burner box to install the regulator and make house
gas supply connections. Use a 90° elbow to route
the gas connections and limit interference with
drawers or other cabinetry.
Cooktop
1/2" Above Adjacent
Countertops
Front of deep cabinets can align
with control panel beveled edge.
Cooktop
1/2" Above Adjacent
Countertops
Front of deep cabinets can align
with control panel beveled edge.
Product Specification Revised 10/18
MONOGRAM 36" PROFESSIONAL GAS RANGETOP
WITH 6 BURNERS (NATURAL GAS)
DIMENSIONS AND INSTALLATION INFORMATION
(IN INCHES)
BACKSPLASH ACCESSORIES
The rangetop requires a 12" minimum clearance to a vertical
combustible surface at the rear. A backsplash is required
for installations with less than 12" clearance. A custom,
non-combustible backsplash can be used.
BACKSPLASH WITH WARMING SHELF
All Monogram Professional Hoods feature infrared warming
lights. The 30"-36" adjustable backsplash with warming
shelf is a perfect complement when installed with the
tapered or straight-sided hoods.
• Restaurant-Style Professional Hoods are shipped
with a 22" stainless steel backsplash and warming shelf.
ZGU366NPSS
ADVANCE PLANNING FOR 36"
PROFESSIONAL RANGETOPS
Professional rangetops oer a number of choices in size
and rangetop configurations.
• All professional rangetops are factory set for natural
gas. Conversion orfices for liquid propane are packed
with product.
HIGH ALTITUDE KIT, WB28K10553,
is also available.
The kits must be installed by a qualified service technician
at additional cost.
SIDE VIEW WITH A BACKSPLASH
ELECTRICAL REQUIREMENTS
Rangetops must be supplied with 120V, 60Hz,
and connected to an individual, properly grounded
branch circuit protected by a 15 amp circuit breaker
or time-delay fuse.
GAS SUPPLY
• Natural gas models are designed to operate at 5" water
column pressure. For proper operation, the pressure
of the natural gas supplied to the regulator must be
between 7" and 13" water column.
• If converted to liquid propane, the models are designed
to operate at 10" water column pressure. For proper
operation, the pressure of the LP source to the regulator
must be between 11" and 13" water column.
Product Specification Revised 10/18
Loading...