Monogram ZGP366NRSS Specsheet
ZGP366NRSS (Natural Gas)
ZGP366LRSS (Liquid Propane)
GE Monogram® 36" All-Gas Professional Range with 6 Burners
Dimensions and Installation Information (in inches)
Professional ranges offer a number of choices in size and
cooktop configurations.
All Professional Ranges are factory set for natural or liquid
propane gas. The correct model should be ordered for the
installation situation.
Note: Conversion kits are included with the range if the wrong
gas type was ordered. High Altitude kit, WB28K10553 for
operation above 6,000 feet (for Natural and LP gas models), is
also available. The kits must be installed by a qualified service
technician at additional cost.
Installation Information
Before installing, consult installation instructions packed
with product or online at Monogram.com for current
dimensional data.
A suitable 30" or wider vent hood is recommended for
installation over this range.
Advance Planning
Refer to dimensional drawings
for appropriate placement and
necessary clearances when planning
the installation.
• Working areas adjacent to the
range should have 18" minimum
clearance between countertop and
cabinet bottom.
• Clearance between range and side
wall or combustible material must
be at least 12" on each side.
• Installation must conform with
local codes. In the absence of local
codes, the range must comply with
the National Fuel Gas Code, ANSI
Z22 3 .1-19 90.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
geappliances.com or call GE Answer Center®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
Specification Revised 4/11
130563
ZGP366NRSS (Natural Gas)
Universal Utility Locations
ZGP366LRSS (Liquid Propane)
GE Monogram® 36" All-Gas Professional Range with 6 Burners
Dimensions and Installation Information (in inches)
Electrical Requirements
Ranges must be hooked up to a 120V, 60Hz properly
grounded dedicated circuit protected by a 15-amp circuit
breaker or time-delay fuse.
Universal Utility Locations
4-5/8”
6-1/2”
13-3/8”
Gas/
Electric
11-3/8”
Gas/
Electric
2”
2”
36”
Locate gas and
electric as shown
Gas Supply
• The natural gas models are designed to
operate at 5" water column pressure.
For proper operation, the pressure of
the natural gas supplied to the regulator
must be between 7" and 13" water
column.
• The LP models are designed to operate
at 10" water column pressure. For
proper operation, the pressure of the LP
gas supplied to the regulator must be
between 11" and 13" water column.
Optional Backsplash Accessories
The range requires a 12" minimum clearance to a vertical
combustible surface at the rear. A backsplash is required
for installations with less than 12" clearance. The following
backsplash accessories are available, or a custom, noncombustible backsplash can be used.
Order one with a 36"-wide range backsplash
ZX12B36PSS–12" backsplash
ZXADJB36PSS– 30"-36" adjustable height
Side View with a Backsplash
28-7/8”
to Front
Edge
Control Panel
28-1/4” to
Beveled
Edge of Control
Panel Bullnose
27-1/2” to
Beveled Edge
- Maximum
Adjacent
Cabinet Depth
for
Flush
Installation
28-1/4”
to Front of
Door
3-3/16”
Depth
31-1/16”
to Front of
Handle
48-1/4”
with Oven Door
Open
7” Control
Panel Height
Optional
Backsplash
Accessories
13/16”
30-36”
35-1/4”
to
36-3/4”
10-1/2”
12”
1-1/2”
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
geappliances.com or call GE Answer Center®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
Specification Revised 4/11
130563
Loading...