Monogram ZGP304NRSS, ZGP304LRSS Specifications

MONOGRAM 30" ALL-GAS PROFESSIONAL

ZGP304NRSS (NATURAL GAS)

RANGE WITH 4 BURNERS

DIMENSIONS AND INSTALLATION INFORMATION
(IN INCHES)

All Professional Ranges are factory set for natural or liquid
propane gas. The correct model should be ordered for the
installation situation.

NOTE

Conversion kits are included with the range if the wrong
gas type was ordered. High Altitude kit, WB28K10553
for operation above 6,000 feet, is also available. The kits
must be installed by a qualified service technician
at additional cost.

INSTALLATION INFORMATION

Before installing, consult installation instructions packed
with product or online at Monogram.com for current
dimensional data.

A suitable 30" or wider vent hood is recommended for
installation over this range.

35 1/4"

to

36 3/4"

height

28 1/4"

Depth
to front
of door

ZGP304LRSS (LIQUID PROPANE)

29 7/8" width

3 1/4"
to 4 3/4"

Toekick/leg

height

ADVANCE PLANNING

Refer to dimensional drawings for appropriate placement
and necessary clearances when planning the installation.

• Working areas adjacent to the range should have
18" minimum clearance between countertop and
cabinet bottom.

• Clearance between range and side wall or combustible
material must be at least 12" on each side.

• Installation must conform with local codes. In the
absence of local codes, the range must comply with the
National Fuel Gas Code, ANSI Z223.1-990.

WARNING

Installations without a hood require 48" minimum
to combustibles. A custom hood installation with
exposed horizontal combustible surfaces must
have an Auto-On feature. Refer to hood installation
instructions for specific hood clearances.

The surface of the entire back wall above the range
and below the hood must be covered with a non­combustible material such as metal, ceramic tile,
brick, marble or other stone.

13"
max.

18"
min.

12" minimum
to adjacent wall

48" minimum
to combustibles

Non-Combustible

Material

12" minimum

each side

30" min.

ADDITIONAL CLEARANCES:

Allow 12" minimum clearance to an adjacent wall
on each side.

Working areas adjacent to the rangetop should have
18" minimum clearance between countertop and
the bottom of the wall cabinet.

Listed by
Underwriters
Laboratories

Product Specification Revised 10/18

MONOGRAM 30" ALL-GAS PROFESSIONAL

Universal Utility Locations

ZGP304NRSS (NATURAL GAS)

RANGE WITH 4 BURNERS

DIMENSIONS AND INSTALLATION INFORMATION
(IN INCHES)

ELECTRICAL REQUIREMENTS

Ranges must be hooked up to a 120V, 60Hz properly
grounded dedicated circuit protected by a 15-amp circuit
breaker or time-delay fuse.

UNIVERSAL UTILITY LOCATIONS

4-5/8"

11-3/8"

6-1/2"

Locate gas and electric as shown

GAS SUPPLY

• The natural gas models are designed to operate at
5" water column pressure. For proper operation, the
pressure of the natural gas supplied to the regulator
must be between 7" and 13" water column.

• The LP models are designed to operate at 10" water
column pressure. For proper operation, the pressure
of the LP gas supplied to the regulator must be
between 11" and 13" water column.

Gas/

Electric

7-3/8"

Gas/

Electric

2"

2"

30"

ZGP304LRSS (LIQUID PROPANE)

OPTIONAL BACKSPLASH ACCESSORIES

The range requires a 12" minimum clearance to a vertical
combustible surface at the rear. A backsplash is required
for installations with less than 12" clearance. A custom,
non-combustible backsplash can be used.

SIDE VIEW WITH A BACKSPLASH

28-7/8"

to Front

Edge

3-3/16"

Control Panel

Depth

28-1/4" to

Beveled

Edge of Control

Panel Bullnose

27-1/2" to

Beveled Edge

- Maximum
Adjacent

Cabinet Depth

for

Flush

Installation

28-1/4"

to Front of

Door

to Front of

31-1/16"

Handle

48-1/4"

with Oven Door

Open

7" Control

Panel Height

Optional
Backsplash
Accessories

13/16"

30-36"

35-1/4"

to

36-3/4"

10-1/2"

12"

1-1/2"

Listed by
Underwriters
Laboratories

Product Specification Revised 10/18