Monogram ZFGB21HZBSS, ZFGP21HZBSS, ZFGB21HZASS, ZFGP21HZASS Installation Instructions Manual

Installation

Instructions

Stoinless Steel Free-Stonding, Drower Freezer Refrigerotor

PO07

monogram.corn

Safet Information

BEFORE YOU BEGIN

Read these instructions completely and carefully.

. IMPORTANT- Savetheseinstructions

for local inspector's use.

. IMPORTANT- Observeellgoverning

codesand ordinances.

. Note to Installer - Be sure to leave these

instructions with the Consumer.

. Note to Consumer - Keep these instructions with

your Owner's Manuel for future reference.

WARNING:

Thisappliancemust be properlygrounded.See "GroundingtheRefrigerator,"page 4.

AVERTISSEMENT:

Cet appareil doit _tre correctement mis 5 la terre. Consulter <<Mise 6 la terredu r6frig6rateur >>,page 4.

If you received a damaged refrigerator, you should immediately contact your dealer or builder.

Skill Level - Installation of this refrigerator requires basic mechanical, carpentry and plumbing skills. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GEAppliance Warranty. See the Owner's Manual for warranty information.

ACAUTION:

Dueto the weight and size of this refrigerator, and to reduce the risk of personal injury or damage to the product - TWO PEOPLEAREREQUIREDFORPROPER

INSTALLATION.

PRUDENCE:

/_cause du poids et de la taille de ce r6frig6rateur et pour r6duire le risque de blessure et de dommoges,

ILFAUTDEUXPERSONNESPOURFAIREL'INSTALLATION CORRECTEMENT.

WARNING:

. Usethis appliance only for its intended purpose,

Immediately repair or replace electric service cords

that become frayed or damaged.

Unplug the refrigerator before cleaning or making

repairs,

Repairs should be made by a qualified service

technician,

AVERTISSEMENT:

. IIne faut utiliser cet appareil que pour I'utilisation

appropri6e.

R6parer ou remplacer imm6diatement tout cordon

61ectriqueeffiloch6 ou endommag6.

IIfaut d6brancher le r6frig6rateur avant le nettogage

ou toute intervention.

Lesr6parations doivent 6tre faites par un technicien

qualifi&

For Monogram local service in your area, call 1.800.444.1845.

For Monogram service in Canada, call 1.800.561.3344

For Monogram Ports and Accessories, coil 1.800.626.2002.

www.monogram.com

CONTENTS

Planning Information

Product Dimensions and Clearances ............................................3

The Installation Space ..........................................................................3

Installation Instructions

Tools, Hardware, Materials ..............................................................4

Grounding the Refrigerator ..............................................................4

Step 1, Measure Cabinet Opening ................................................5

Step 2, Install Anti-Tip Bracket ....................................................5-6

Step 3, Install the Refrigerator ........................................................7

Step 4, Remove the Freezer Drawers ......................................7-8

Step 5, Remove the Fresh Food Doors ........................................8

Step 6, Remove the Toekick ............................................................9

Step 7, Move the Refrigerator ........................................................9

Step Step Step Step Step Step Step Step Step Step Step Step

8, Replace the Freezer Drawers ..................................9-10

9, Replace Fresh Food Doors .............................................

10, Install Water Line .............................................................

IOA, ROWater Line ................................................................2

11, Connect Water Supply ..................................................2

12, Connect Power ..................................................................2

13, Move Refrigerator Into Position ................................2

1/4,Level Refrigerator ............................................................3

15, Level Doors ..........................................................................1

16, Install Toekick ......................................................................

17, Start Icemaker ..................................................................

18,Temperature Controls ....................................................1

Plannin Information

PRODUCT DIMENSIONS AND CLEARANCES

35-7/8" | 27-1/2" |

CaseWidth -'_ Depth d

69-5/8"

35-7/8"

DepthIncludingHandles._//z

29-1/2"-TubularHandles

30-1/4"-ProfessionalHandles

These Monogram free-standing refrigerators require the following clearances for proper air circulation, plumbing and electrical connections.

Installation in a corner:

. Allow 4" clearance on each side to an adjacent wall for a

90° opening and accessto drawers.

Air Circulation Clearances: .1/8" on each side .1/2" at the back side

_15 F15'!

...................................!il,

g0°DoorSwing

I I I

24-5/8"

. Allow lS" clearance to wall on each side for removal

of drawers.

THE INSTALLATION SPACE

The opening width must be at least 36".

70" min.

36" min.

Electrical

Area

Water Supply

WallView

Water And Electrical Locations The opening must be prepared with the electrical and

water supply located as shown. Additional Specifications

. A !!5 volt 60Hz., !5 or 20 amp power supplu is required.

An individual properlu grounded branch circuit or circuit

breaker is recommended. Install a properlu grounded

3-prong electrical receptacle recessed into the back wall.

NOTE:GFI(ground fault interrupter)is not recommended.

. The cold water line can enter the opening through the

floor or through an adjacent cabinet, as close to the back wall as possible.The water line should be GE SmartConnect TM Refrigerator Tubing or 1/4" O.D.copper tubing between the cold water line and water connection

location at the rear of the refrigerator. Installation of an

easily accessible shut off valve in the water line is

recommended.

Installation Instructions

TOOLS REQUIRED

. Adjustable wrench .3/8" and 5/15" socket ratchet/driver

. Phillipshead screwdriver .3/32", !/8", !/4" Allen wrenches .1/8" Drill bit and electric or hand drill

. Tape measure . Pencil

. Wire cutters . !/4" Nut driver . Level

FLOORI NG

Forproper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. This surface should be strong enough to support a fullg loaded refrigerator.

IMPORTANT NOTE:Protect the finish of the flooring. Cut a large section of the cardboard carton and place under the refrigerator where gou are working.

MATERIALS REQUIRED

.1/4" O.D.compression nut and 2 ferrules (sleeves)

ORGESmartConnect TM Refrigerator Tubing Kits

GROUNDING THE REFRIGERATOR

IMPORTANT- (Please read carefully} FORPERSONALSAFETY,THIS APPLIANCEMUSTBE

PROPERLYGROUNDED.

The power cord of this appliance isequipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall receptacle to minimize the possibilitg of electric shock hazard from this appliance.

Have the wall outlet and circuit checked bg a qualified electrician to make sure the outlet is properlg grounded.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG

FROM THE POWER CORD.

DO NOT USE AN ADAPTER PLUG TO CONNECT THE REFRIGERATORTO A 2-PRONG OUTLET.

DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

Where a standard 2-prong wall outlet is encountered, it is gout personal responsibilitg and obligation to have it replaced with a properlg grounded :3-prong

wall outlet.

Installation Instructions

WARNING

Under certain circumstances, this refrigerator

can tip forward.

Injury to persons can result. Install Anti-Tip Bracket packed with this refrigerator.

[STEP i

MEASURE CABINET OPENING AVAILABLE VS. REFRIGERATOR WIDTH

Measure width of cabinet opening where refrigerator

will be placed, W.

Be sure to account for ang countertop overhang,

baseboard thickness and ang clearance desired. Width, W, should not be lessthan :36inches. The refrigerator will be placed approximatelg

in the middle of this opening.

i i i i i 141

RearWall

REFRIGERATOR

i i

Baseboard

Thickness

orCountertop Overhang (Whichever isGreater)Plus AnyDesired Clearance

RHSide

Front

iSTEP 2i LOCATE ANTI-TIP BRACKET

A. Place the anti-tip floor bracket Iocutor template

(included inside the anti-tip kit) onto the floor up against the rear wall, within W, and in line with the desired location of the RHside of the refrigerator (seeFigure !).

Figure I - Installation Overview

Floor-Concrete 2Wall Holes (2Holes) Floor-Wood '_ FloorBracket

..................(2Holes) /to Install

RHHoles

RearRH

- -- _ Cornerof

Base / - _ Locater Bracketon . --J-- " _ TemplateCabinetWall

-- "_ Sideof

theRefrigerator _ Sheet

Refrigerator

B. Placethe anti-tip floor bracket onto the Iocator

template with its RHfloor holes lined up with the floor holes indicated on the template sheet, approxi-

matelg 7-1/4" from the edge of the sheet or the RH side of the refrigerator.

C. Hold down in position and use the anti-tip floor

bracket as a template for marking the holes based upon gout configuration and tgpe of construction as shown in Step 3. Mark the hole locations with a pencil, nail or awl.

NOTE: It is REQUIREDto use at least 2 screws to mount the floor bracket (one on each side of the

anti-tip floor bracket). Both must be into either the wall or the floor. Figure 2 indicates all the acceptable mounting configurations for screws. Identifg the screw holes on the anti-tip floor bracket for gout configuration.

+ 11 hidden pages

Monogram ZFGB21HZBSS, ZFGP21HZBSS, ZFGB21HZASS, ZFGP21HZASS Installation Instructions Manual

Specifications and Main Features

Frequently Asked Questions

User Manual