Monogram ZDP486NRPSS Installation
If you have questions, call 800-GE-CARES or visit our website at: www.monogram.com
Installation
Instructions
Professional Ranges
48" Natural Gas Models
ZDP48N4G
ZDP48N6R
ZDP48N6D
48" LP Gas Models
ZDP48L4G
ZDP48L6R
ZDP48L6D
36" Natural Gas Models
ZDP36N6
ZDP36N4R
ZDP36N4D
36" LP Gas Models
ZDP36L6
ZDP36L4R
ZDP36L4D
30" Natural Gas Model
ZDP30N4
30" LP Gas Model
ZDP30L4
CAUTION:
THESE RANGES SHOULD BE INSTALLED
IN CONJUNCTION WITH A SUITABLE
OVERHEAD VENT HOOD. Due to the high heat capacity
of this unit, particular attention should be paid to the
hood and duct work installation to assure it meets
local building codes.
MISE EN GARDE :
CES CUISINIÈRES DOIVENT ÊTRE
MONTÉES CONJOINTEMENT AVEC UNE
HOTTE À ÉVACUATION DE PLAFOND APPROPRIÉE.
Étant donné la grande capacité thermique de cet
appareil, une attention particulière doit être portée
au montage de la hotte et du système de gaines pour
s’assurer qu’il est conforme aux codes du bâtiment
locaux.
Standard countertop and island installations:
A 1200 CFM hood is recommended for 48" ranges.
A 600 CFM hood is recommended for 30" and 36" Ranges.
Hoods should be 24" min. deep and the same width as
the cooktop.
Check local building codes for the proper method of
gas range installation. Local codes vary. Installation,
electrical connections and grounding must comply
with applicable codes. In the absence of local codes,
the gas range should be installed in accordance with
the National Fuel Gas Code ANSI 223.1, latest
edition and National Electrical Code ANSI/NFPA 70,
latest edition.
CAUTION:
These ranges weigh up to 600 pounds.
Some disassembly will reduce the weight
considerably. Due to the weight and size of the range
and to reduce the risk of personal injury or damage
to the product, TWO PEOPLE ARE REQUIRED FOR
PROPER INSTALLATION.
MISE EN GARDE :
Ces cuisinières pèsent jusqu’à
272 kg (600 lb). Tout démontage réduira
considérablement leur poids. En raison du poids et
de la taille de la cuisinière, dont la manipulation risque
d’entraîner des lésions corporelles ou des dommages
au produit, DEUX PERSONNES SONT NÉCESSAIRES
POUR PROCÉDER À UN MONTAGE ADÉQUAT.
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
• IMPORTANT – Save these instructions for
local inspector’s use.
• IMPORTANT – Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Skill Level – Installation of this range requires basic
mechanical and electrical skills.
• Completion time – 1 to 3 hours.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
WARNING:
This appliance must be properly grounded.
See “Electric Supply”, page 7.
AVERTISSEMENT :
Cet appareil doit être mis à la terre
adéquatement. Voir la section « Alimentation
électrique » à la page 7.
For Monogram local service in your area,
1.800.444.1845.
For Monogram Service in Canada, call
1.888.880.3030.
For Monogram Parts and Accessories, call
1.800.626.2002.
If you received a damaged range, you should contact
your dealer.
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber
or gas fitter.
• When using ball type gas shut off valves, they shall
be T-handle type.
• A flexible gas connector, when used, must not
exceed 3 feet.
2
Installation Instructions
22" High Backsplash With
Warming Shelf
12" High Backsplash
(9" High for 30" Models)
INSTALLATION NOTE:
A custom backspash may be constructed of non-combustible back wall materials such as ceramic tile, brick, marble
or other stone.
CONTENTS
Design Information
Models Available ..............................................................3
Accessory Requirements ................................................3
Product Dimensions and Clearances ........................4, 5
Advance Planning ............................................................6
Tools and Materials Required ...................................... 6
Installation Preparation
Power Supply Locations ..................................................7
Installation Instructions
Step 1, Remove Packaging ..............................................8
Step 2, Level the Range ....................................................9
Step 3, Install Anti-Tip Device ..................................9, 10
Step 4, Connect Range to Gas ......................................11
Step 5, Connect Electrical..............................................12
Step 6, Slide Range into Position ................................12
Step 7, Replace Oven Doors ..........................................12
Step 8, Assemble and Adjust Burners ........................13
Finalize Installation..........................................................13
Installation Checklist ......................................................14
Install Backsplash Accessory ......................................15
MODELS AVAILABLE
These ranges are factory set for either natural
gas or liquid propane gas. Order the model for your
installation situation.
48" Natural Gas Models:
ZDP48N4G – 4 gas burners, grill and griddle
ZDP48N6R – 6 gas burners and grill
ZDP48N6D – 6 gas burners and griddle
48" Liquid Propane Gas Models:
ZDP48L4G – 4 gas burners, grill and griddle
ZDP48L6R – 6 gas burners and grill
ZDP48L6D – 6 gas burners and griddle
36" Natural Gas Models:
ZDP36N6 – 6 gas burners
ZDP36N4R – 4 gas burners and grill
ZDP36N4D – 4 gas burners and griddle
36" Liquid Propane Gas Models:
ZDP36L6 – 6 gas burners
ZDP36L4R – 4 gas burners and grill
ZDP36L4D – 4 gas burners and griddle
30" Natural Gas Model:
ZDP30N4
30" Liquid Propane Gas Model:
ZDP30L4
3
BACKSPLASH ACCESSORIES
All models require 12" min. clearance to a vertical
combustible surface at the rear. A backsplash
accessory is available for installations with less
than 12" clearance to the back wall. Order a 12" high
backsplash or 22" high backsplash with warming shelf.
Backsplash for 48" Models:
ZX12B48HSS – 12" high backsplash
ZX22B48HSS – 22" high backsplash with warming shelf
(2 piece)
Backsplash for 36" Models:
ZX12B36HSS – 12" high backsplash
ZX22B36HSS – 22" high backsplash with warming shelf
(2 piece)
Backsplash for 30" Models:
ZX9B30HSS – 9" high backsplash
ZX22B30HSS – 22" high backsplash with warming shelf
(2 piece)
Design Information
48" and 36" Range Models
4
PRODUCT DIMENSIONS AND CLEARANCES
48" Wide Range Models
36" Wide Range Models
22"
12"
1-1/2"
35-1/4"-36-3/4"
28-1/4"
47-7/8"
O
p
t
io
n
a
l B
a
c
k
s
p
la
s
h
22"
1-1/2"
35-1/4"-36-3/4"
28-1/4"
35-7/8"
O
p
t
io
n
a
l B
a
c
k
s
p
la
s
h
12"
Design Information
NOTE: 12" Min. to Combustibles or
0" Min to Combustibles with any
backsplash accessory or custom
non-combustible back wall.
22"
9-1/2"
3/4"
12"
29-1/16"
22" High
Backsplash
with Shelf
12" High Backsplash
0" Clearance
26"
28-1/4"
31-1/2"
45-5/8"
36" Min.
to Combustibles
12" Min. to Combustibles or
0" Min. to Combustibles
with 12" or 22" Backsplash
36" Min.
to
Combustibles
Backguard
0" Clearance
4"
18" Min.
30" Wide Models 4"
36" Wide Models 4"
48" Wide Models 8"
35-3/8" Max. for Counter Level
36-3/4" Max. with Range Leveling Legs Fully Extended
1-1/2"
Gas Supply
Electrical Supply
Cooking Surface
13"
Max.
30"/36" Wide Models 4"
48" Wide Models 8"
30" Wide Models 8"
36" Wide Models 12"
48" Wide Models 16"
30" Wide Range Hood
Or
36" Wide Range Hood
Or
48" Wide Range Hood
12" Min. to
Combustible
Material
Each Side
36" Min. to
Combustible
Material From
Cooking Surface
12"
30" Wide Range Models
35-1/4"-36-3/4"
26-3/4"
29-7/8"
22"
1-1/2"
O
p
t
io
n
a
l B
a
c
k
s
p
la
s
h
9"
NOTE: Refer
to Vent Hood
Installation
Instructions
for hood height
above the range.
5
PRODUCT DIMENSIONS AND CLEARANCES
Design Information
9-1/2"
3/4"
22"
9"
27-3/8"
22" High
Backsplash
with Shelf
9" High Backsplash
0" Clearance
26-3/4"
29-1/4"
43-7/8"
36" Min.
to Combustibles
Loading...