Monogram ZDP484NGPSS Specsheet
RANGE WITH 6 BURNERS, GRILL AND GRIDDLE
DIMENSIONS AND INSTALLATION INFORMATION
(IN INCHES)
Professional ranges oer a number of choices in size and
cooktop configurations.
All Professional Ranges are factory set for natural or liquid
propane gas. The correct model should be ordered for the
installation situation.
35 1/4"
NOTE
Conversion kits are included with the range if the wrong
gas type was ordered. High Altitude kit, WB28K10553
for operation above 3,000 feet (for Natural and LP gas
models), is also available. The kits must be installed
by a qualified service technician at additional cost.
INSTALLATION INFORMATION
Before installing, consult installation instructions packed
with product or online at Monogram.com for current
dimensional data.
A 48" or 54" wide professional vent hood with a minimum
1200 CFM is recommended for installation over this range.
to
36 3/4"
height
28 1/4"
Depth
to front
of door
ZDP484NGPSS (NATURAL GAS)MONOGRAM 48" DUAL-FUEL PROFESSIONAL
47 7/8" width
3 1/4"
to 4 3/4"
Toekick/leg
height
ADVANCE PLANNING
Refer to dimensional drawings for appropriate placement
and necessary clearances when planning the installation.
• Working areas adjacent to the range should have 18"
minimum clearance between countertop and cabinet
bottom.
• Clearance between range and side wall or combustible
material must be at least 12" on each side.
• Installation must conform with local codes. In the
absence of local codes, the range must comply with
the National Fuel Gas Code, ANSI Z223.1-1990.
WARNING
Installations without a hood require 48" minimum
to combustibles. A custom hood installation with
exposed horizontal combustible surfaces must
have an Auto-On feature. Refer to hood installation
instructions for specific hood clearances.
The surface of the entire back wall above the range
and below the hood must be covered with a noncombustible material such as metal, ceramic tile,
brick, marble or other stone.
13"
max.
18"
min.
12" minimum
to adjacent wall
48" minimum
to combustibles
Non-Combustible
Material
12" minimum
each side
48" min.
ADDITIONAL CLEARANCES:
Allow 12" minimum clearance to an adjacent wall
on each side.
Working areas adjacent to the rangetop should have
18" minimum clearance between countertop and
the bottom of the wall cabinet.
Listed by
Underwriters
Laboratories
Product Specification Revised 4/17
RANGE WITH 6 BURNERS, GRILL AND GRIDDLE
28-7/8"
Optional
Backsplash
A
12" min. to combustibles or 0" to
a non-combustible material above
the cooking surface
DIMENSIONS AND INSTALLATION INFORMATION
(IN INCHES)
ZDP484NGPSS (NATURAL GAS)MONOGRAM 48" DUAL-FUEL PROFESSIONAL
ELECTRICAL REQUIREMENTS
Ranges must be supplied with 208/240V, 60Hz, and
connected to an individual, properly grounded branch
circuit protected by a circuit breaker or time-delay fuse.
Install a 50-amp circuit for 48" ranges. The receptacle must
be a NEMA 14-50R device to accept the four-prong plug
on the range.
UNIVERSAL UTILITY LOCATIONS
8"
14" 16"
6-1/2"
Gas/
Electric
Electric
2"
2"
48"
Locate gas and electric as shown
GAS SUPPLY
• The natural gas models are designed to operate at
5" water column pressure. For proper operation, the
pressure of the natural gas supplied to the regulator
must be between 7" and 13" water column.
• The LP models are designed to operate at 10" water
column pressure. For proper operation, the pressure of
the LP gas supplied to the regulator must be between
11" and 13" water column.
6-1/2"
OPTIONAL BACKSPLASH ACCESSORIES
The range requires a 12" minimum clearance to a vertical
combustible surface at the rear. A backsplash is required
for installations with less than 12" clearance. The following
backsplash accessories are available, or a custom, noncombustible backsplash can be used.
ORDER ONE WITH A 48"-WIDE RANGE BACKSPLASH
ZX12B48PSS–12" backsplash
ZXADJB48PSS– 30"-36" adjustable-height
backsplash with warming shelf
SIDE VIEW WITH A BACKSPLASH
to Front
Edge
3-3/16"
Control Panel
Depth
28-1/4" to
Beveled
Edge of Control
Panel Bullnose
27-1/2" to
Beveled Edge
- Maximum
Adjacent
Cabinet
Depth for
Flush
Installation
28-1/4"
to Front of
Door
31-1/16"
to Front of
Handle
Countertop level
48-1/4"
with Oven Door
Open
7" Control
Panel Height
ccessories
13/16"
30-36"
35-1/4"
to
36-3/4"
10-1/2"
12"
1"
0" clearance
to a back or
side wall below
the cooking
surface
Listed by
Underwriters
Laboratories
Product Specification Revised 4/17
Loading...