MONOCURE 3DR3588GY User Manual

MONOCURE 3DR3588GY

3D RAPID UV RESIN - GREY

END USE

Monocure 3D RAPID grey photo-reactive resin has been designed to use in low
powered LED type DLP 3D Printers for UV wavelengths from 225nm to 420nm. The
near solid grey appearance allows you to 3D print models or parts with a detailed
smooth finish that will be grey when cured.

PHYSICAL PROPERTIES

Colour

Grey (5% Transparency)

Viscosity

500 - 600cps @ 25°C (Brookfield RVT)

Odour

Negligible Characteristics

Shelf Life

12 months

Active Solids

100%

UV Cure

225nm to 420nm

Cure Speed

Very fast with UV LED LAMPS

Storage

Dark Cool, dry place out of direct sunlight.

Wash Up

IPA (Isopropyl Alcohol)

APPLICATION

Stereolithography (SLA) is an additive manufacturing process that employs a vat of
liquid ultraviolet curable photopolymer resin and an ultraviolet laser to build parts'
layers one at a time. For each layer, the laser beam traces a cross-section of the part
pattern on the surface of the liquid resin. Exposure to the ultraviolet laser light cures
and solidifies the pattern traced on the resin and joins it to the layer below.

Digital Light Projection (DLP) is similar to SLA however it uses a digital light projector
to harden the resin instead of a laser. The main advantages are that is can harden a
whole layer in a lot less of the time it takes to a laser to trace around and fill in each
item on the print bed.

PACKAGING

Monocure 3DR3588GY is packed in 500ml, 1ltr & 5ltr black plastic containers with a
screw-top cap.