Monitor Audio 300 User Manual

Installation Guide

300 Series

Installation guide

300 Series

The 300 Series models utilise RST® bass drivers and a high specification version of the C-CAM® gold dome tweeter. These
models offer a higher grade of performance, and greater flexibility.

The RST® (Rigid Surface Technology) drivers are more commonly found in our Gold Signature Series. The drivers used are
our second generation of our RST®. The cone profile has been further refined using “Finite Element Analysis”, to provide a
smoother response and reduced break up. The 300 Series is also the first range of speakers to feature a 8” version of the
RST® driver.

The pivoting tweeter is based on Monitor Audio’s famous 25mm gold C-CAM® dome. Improvements to the surround and
motor system have extended the frequency response to beyond 30 kHz, so that it is ready to exploit HD digital cinema and
audio formats.

The LCR models employ a unique Inverted Dual Concentric (IDC®) pivoting mid-range/tweeter module, providing up to 18
degrees of movement and allowing the sound to be directed towards the desired listening zone. These models offer superior
performance and flexibility over typical 2-way or fixed angle speaker designs.

The FX model features a switchable di-pole mode. The technology behind this is also found on the Gold Signature
surround speakers, the GSFX. There is a three position switch to control this feature. It can be set to bi-pole (normal operation),
di-pole, or trigger. When set to trigger, the di-pole mode is controlled by a 12v trigger found in high end AV amplifiers/receivers.
Di-pole mode enhances the whole movie experience when used in a 7.1 channel system. For configuration information please
go to www.monitoraudio.co.uk/
support.

The high frequency level control together with boundary compensation control facilitates a wider range of possible
adjustments. See page 2.

Introduction

Please read this installation guide carefully before proceeding.

ALSO AVAILABLE: Pre-construction brackets. These are for use when installing any Custom Installation product before the

plaster board/ rock wall, is fitted. They show the location of the speakers to the builder, allow pre-wiring and give them a solid
secure edge to cut around. Please ask your dealer about these brackets and to confirm which is correct for your installation.

PLEASE CHECK YOU HAVE THE FOLLOWING ITEMS IN THIS KIT BEFORE PROCEEDING:

• 1 x Complete speaker & tweeter assembly.

• 1 x Grille (which can be painted).

• 1 x Mounting cut out template (in packaging).

• 1 x Plastic paint mask (for covering the baffle while painting the frame).

• 1 x Self adhesive grille membrane scrim (to be attached to the inside the grille after it has been painted).

• 1 x Guarantee card in this manual.

Prior to Installation Check the Following:

• Please check the minimum depth of the product (according to the specifications sheet) is correct for the assembly to fit into
recess.

• The fixing clamps require a minimum of 25mm (1 Inch) of surface area around the cut-out hole to ensure a secure fixing!

• Series 300 loudspeakers are splash and moisture proof, so they can be used in bathrooms, pool areas, etc. DO NOT allow
them to be in constant contact with water/moisture.

• The fixing clamps will operate on ceilings/walls with a minimum thickness of 9mm (3/8 Inches) to a maximum depth of
32mm (1¼ Inches).

• Do not attempt to fix these speakers to your ceiling/wall if you are unsure of your ability to provide a secure and safe fixing.
IF IN DOUBT CONTACT YOUR LOCAL AUTHORISED MONITOR AUDIO DEALER.

• Ensure that there are no water pipes, air ducts or electricity cables running immediately behind the cut out area!

• Please work from secure steps or scaffold and avoid trailing wires for your safety and those around you.

• Always turn off the amplifier or other devices in the system when connecting these speakers.

1