Monicon Instruments PCH-051, PCH-052 User Manual
Automatic Portable
Battery Charger
PCH-051
PCH-052
User Manual
Tel：886-4-2238-0698
Fax：886-4-2238-0891
Website：http://www.monicon.com.tw
e-mail：sales@monicon.com.tw
Copyright © 2010 Monicon Instruments Co., Ltd. All rights reserved. Contents in this
publication may not be reproduced in any form without the written permission from Monicon
Instruments Co., Ltd
Monicon Instrument Co.,Ltd. PCH051 / PCH052
Please read all warnings and safety guide before operating PCH-051/052. Users
are responsible for any regulations required by special applications. Please
do not connect AC power before installation. Warranty will be void if
installation was not followed by the user manual and may risk of electrical shock,
fire or injury.
。
Important Safety Guide
1. Do not place the charger under rain, direct sunlight, dust condition, acidic or
corrosive gas environment.
2. To prevent over heating, do not block ventilation area or installed in a sealed
area.
3. PCH-051/052 is equipped with automatic charging loop detection. User do not need
to turn off the charger or disconnect from the battery, it stops charging after
the battery is been fully charged.
4. Please use only factory parts and suggested accessories. Unauthorized parts may
risk of shock, fire, or injury.
5. Please do not disassemble PCH-051/052. Attempting to repair the machine may risk
of fire and shock.
6. PCH-051/052 still contains residual electricity even if the power and battery are
been removed.
7. Please make sure the AC ground wire from PCH-051/052 is been properly grounded.
Improper connection may risk of electrical shock, fire, or injury.
8. Please remove ac power and battery wire before performing cleaning or maintenance.
9. Please do not use PCH-051/052, if high pitch pop sound occurred.
10. Please do not use damaged or low grade wires.
11. Due to the nature of lead acid battery, hydrogen and oxygen gas are been released
during charging period. Please operate the charger in a well ventilated area.
12. Please do not press and hold the forced output button for a long period of time
or tape the button. Fuse should only be replaced with the same specification.
Loading...